lkml.org 
[lkml]   [2023]   [Jul]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/4] pinctrl: amd: Use amd_pinconf_set() for all config options
On Wed, Jul 05, 2023 at 08:30:03AM -0500, Mario Limonciello wrote:
> On ASUS TUF A16 it is reported that the ITE5570 ACPI device connected to
> GPIO 7 is causing an interrupt storm. This issue doesn't happen on
> Windows.
>
> Comparing the GPIO register configuration between Windows and Linux
> bit 20 has been configured as a pull up on Windows, but not on Linux.
> Checking GPIO declaration from the firmware it is clear it *should* have
> been a pull up on Linux as well.
>
> ```
> GpioInt (Level, ActiveLow, Exclusive, PullUp, 0x0000,
> "\\_SB.GPIO", 0x00, ResourceConsumer, ,)
> { // Pin list
> 0x0007
> }
> ```
>
> On Linux amd_gpio_set_config() is currently only used for programming
> the debounce. Actually the GPIO core calls it with all the arguments
> that are supported by a GPIO, pinctrl-amd just responds `-ENOTSUPP`.
>
> To solve this issue expand amd_gpio_set_config() to support the other
> arguments amd_pinconf_set() supports, namely `PIN_CONFIG_BIAS_PULL_DOWN`,
> `PIN_CONFIG_BIAS_PULL_UP`, and `PIN_CONFIG_DRIVE_STRENGTH`.

...

> @@ -782,7 +770,7 @@ static int amd_pinconf_get(struct pinctrl_dev *pctldev,
> }
>
> static int amd_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin,
> - unsigned long *configs, unsigned num_configs)
> + unsigned long *configs, unsigned int num_configs)

Seems like a stray change.

> {
> int i;
> u32 arg;

Otherwise entire series looks good to me,
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>

--
With Best Regards,
Andy Shevchenko


\
 
 \ /
  Last update: 2023-07-06 11:17    [W:0.125 / U:0.268 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site