Messages in this thread | | | Date | Wed, 14 Jun 2023 12:17:35 +0100 | Subject | Re: [PATCH v7 10/10] pwm: dwc: use clock rate in hz to avoid rounding issues | From | Ben Dooks <> |
| |
On 16/02/2023 21:39, Uwe Kleine-König wrote: > On Fri, Dec 23, 2022 at 03:38:20PM +0000, Ben Dooks wrote: >> As noted, the clock-rate when not a nice multiple of ns is probably >> going to end up with inacurate caculations, as well as on a non pci > > Given that such a non-nice ca*l*culation only happens in the of case > that is introduced here, it would be nice to move this patch before the > introduction of the of-support.
I've moved of support to the end of the series you >> system the rate may change (although we've not put a clock rate >> change notifier in this code yet) so we also add some quick checks >> of the rate when we do any calculations with it. > > If the clk rate changes while the PWM is on, this modifies the output. > This is unfortunate and so it justifies adding a call to > clk_rate_exclusive_get() when the PWM is on.
I can't really test things any more as the hardware has been returned to the client and I'm technically off the project (and awaiting this email address to be closed down).
Could this either be solved by the clk_rate_exclusive_get() or adding a clock change notifier? Either way I would prefer this to be work for another patch.
I'll send v8 out later as it has had some re-works due to moving things around.
Thank you for the review.
-- Ben
| |