lkml.org 
[lkml]   [2023]   [May]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: vPASID capability for VF
On 5/11/23 3:27 PM, Tian, Kevin wrote:
>> From: Alex Williamson<alex.williamson@redhat.com>
>> Sent: Thursday, May 11, 2023 1:25 AM
>>
>> On Tue, 9 May 2023 08:34:53 +0000
>> "Tian, Kevin"<kevin.tian@intel.com> wrote:
>>
>>> According to PCIe spec (7.8.9 PASID Extended Capability Structure):
>>>
>>> The PASID configuration of the single non-VF Function representing
>>> the device is also used by all VFs in the device. A PF is permitted
>>> to implement the PASID capability, but VFs must not implement it.
>>>
>>> To enable PASID on VF then one open is where to locate the PASID
>>> capability in VF's vconfig space. vfio-pci doesn't know which offset
>>> may contain VF specific config registers. Finding such offset must
>>> come from a device specific knowledge.
>> Backup for a moment, VFs are governed by the PASID capability on the
>> PF. The PASID capability exposes control registers that imply the
>> ability to manage various feature enable bits. The VF owner does not
>> have privileges to manipulate those bits. For example, the PASID Enable
>> bit should restrict the endpoint from sending TLPs with a PASID prefix,
>> but this can only be changed at the PF level for all associated VFs.
>>
>> The protocol specified in 7.8.9.3 defines this enable bit as RW. How do
>> we virtualize that? Either it's virtualized to be read-only and we
>> violate the spec or we allow it to be read-write and it has no effect,
>> which violates the spec.
>>
> Currently the PASID cap is enabled by default when a device is probed
> by iommu driver. Leaving it enabled in PF while guest wants it disabled
> in VF is harmless. W/o proper setup in iommu side the VF cannot
> do real work with PASID.

[sorry for partial reply]

I am attempting to move PASID enabling/disabling out of the iommu
driver and give its control to the device driver. One puzzle thing is
that PCI spec requires PASID control bits not changed once the ATS is
is enabled. So I also need to add iommu interfaces to enable/disable
ATS on devices.

By default, the ATS is enabled by the iommu subsystem to utilize the
device TLB, the device driver needs to disable it before change the
PASID control bits and re-enable it afterwards.

I have patches in my local tree, if the pasid virtualization requires
them, I can bring it up for discussion.

Best regards,
baolu

\
 
 \ /
  Last update: 2023-05-11 13:35    [W:0.145 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site