lkml.org 
[lkml]   [2023]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RFC PATCH 5/5] can: m_can: Add hrtimer to generate software interrupt
On 18.04.2023 15:59:57, Mendez, Judith wrote:
> > > > > > > The "shortest" 11 bit CAN ID CAN frame is a Classical CAN frame with DLC = 0
> > > > > > > and 1 Mbit/s (arbitration) bitrate. This should be 48 bits @1Mbit => ~50
> > > > > > > usecs
> > > > > > >
> > > > > > > So it should be something about
> > > > > > >
> > > > > > > 50 usecs * (FIFO queue len - 2)
> > > > > >
> > > > > > Where does the "2" come from?
> > > > >
> > > > > I thought about handling the FIFO earlier than it gets completely "full".
> > > > >
> > > > > The fetching routine would need some time too and the hrtimer could also
> > > > > jitter to some extend.
> > > >
> > > > I was assuming something like this.
> > > >
> > > > I would argue that the polling time should be:
> > > >
> > > > 50 µs * FIFO length - IRQ overhead.
> > > >
> > > > The max IRQ overhead depends on your SoC and kernel configuration.
> > >
> > > I just tried an educated guess to prevent the FIFO to be filled up
> > > completely. How can you estimate the "IRQ overhead"? And how do you catch
> > > the CAN frames that are received while the IRQ is handled?
> >
> > We're talking about polling, better call it "overhead" or "latency from
> > timer expiration until FIFO has at least one frame room". This value
> > depends on your system.
> >
> > It depends on many, many factors, SoC, Kernel configuration (preempt RT,
> > powersaving, frequency scaling, system load. In your example it's 100
> > µs. I wanted to say there's an overhead (or latency) and we need enough
> > space in the FIFO, to cover it.
> >
>
> I am not sure how to estimate IRQ overhead, but FIFO length should be 64
> elements.

Ok

> 50 us * 62 is about 3.1 ms and we are using 1 ms timer polling interval.

Sounds good.

> Running a few benchmarks showed that using 0.5 ms timer polling interval
> starts to take a toll on CPU load, that is why I chose 1 ms polling
> interval.

However in the code you use 5 ms.

Marc

--
Pengutronix e.K. | Marc Kleine-Budde |
Embedded Linux | https://www.pengutronix.de |
Vertretung Nürnberg | Phone: +49-5121-206917-129 |
Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-9 |
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2023-04-19 08:15    [W:1.366 / U:0.140 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site