Messages in this thread | | | Date | Sun, 16 Apr 2023 01:47:56 +0100 | From | Andre Przywara <> | Subject | Re: [PATCH 2/3] ARM: dts: sun5i: Add port E pinmux settings for mmc2 |
| |
On Sat, 15 Apr 2023 18:46:24 +0100 Jonathan McDowell <noodles@earth.li> wrote:
Hi,
> These alternate pins for mmc2 are brought out to the 40 pin U14 header > on the C.H.I.P and can be used to add an external MMC device with a 4 > bit interface. See > > https://byteporter.com/ntc-chip-micro-sd-slot/ > > for further details on how. > > Signed-off-by: Jonathan McDowell <noodles@earth.li> > --- > arch/arm/boot/dts/sun5i.dtsi | 8 ++++++++ > 1 file changed, 8 insertions(+) > > diff --git a/arch/arm/boot/dts/sun5i.dtsi b/arch/arm/boot/dts/sun5i.dtsi > index 250d6b87ab4d..e4922506ce22 100644 > --- a/arch/arm/boot/dts/sun5i.dtsi > +++ b/arch/arm/boot/dts/sun5i.dtsi > @@ -517,6 +517,14 @@ mmc2_4bit_pc_pins: mmc2-4bit-pc-pins { > bias-pull-up; > }; >
As this seems to be a highly non-standard and rare modification, that doesn't even get used in the mainline DT, please add a: /omit-if-no-ref/ line, so we don't get this into every sun5i board.
Otherwise looks good, though I don't know if that should belong into the same DT overlay that is probably used to also enable the MMC2 node.
Cheers, Andre
> + mmc2_4bit_pe_pins: mmc2-4bit-pe-pins { > + pins = "PE4", "PE5", "PE6", "PE7", > + "PE8", "PE9"; > + function = "mmc2"; > + drive-strength = <30>; > + bias-pull-up; > + }; > + > mmc2_8bit_pins: mmc2-8bit-pins { > pins = "PC6", "PC7", "PC8", "PC9", > "PC10", "PC11", "PC12", "PC13",
| |