lkml.org 
[lkml]   [2023]   [Mar]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v1 1/2] dt-bindings: iio: adc: adding dt-bindings for PAC193X
From
On 06/03/2023 14:53, Marius.Cristea@microchip.com wrote:
>
> Hi Jonathan,
>
> Thank you so much! I'm happy to contribute to IIO.
>
> I will remove some section because I agree with the propose solution.
> For the rest I will comment below..
>
>
>
> On Sat, 2023-02-25 at 17:17 +0000, Jonathan Cameron wrote:
>>>> +
>>>> +  microchip,samp-rate:
>>>> +    $ref: /schemas/types.yaml#/definitions/uint32
>>>> +    description: Sampling rate for all device's channels.
>>>
>>> What are the units? rate is usually in hz, which should be
>>> expressed in
>>> unit suffix (property name)]
>>
>> It's unusual for sampling rate to be a property of the hardware and
>> hence
>> suitable for DT binding. Normally we make this a userspace control
>> instead.
>> If there is a reason for doing it from DT, that wants to be mentioned
>> here.
>>
>
> Here I could change it into the datarate (as in
> iio/adc/ti,ads1015.yaml). The units are samples per second. My
> intention was to be alingned with the datasheet.
>
> My intention was to let the user configure the sample rate as soon as
> posile during the startup (the PAC device's own power consumtion will
> increase with the sampling rate - default the chip will start with the
> maximum samples per second).

Then maybe the default should be just lowest rate and user will adjust
it further? Since this is user-space knob, why this should be even
configurable per board?


Best regards,
Krzysztof

\
 
 \ /
  Last update: 2023-03-27 00:46    [W:0.063 / U:0.528 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site