lkml.org 
[lkml]   [2023]   [Mar]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v1 RESEND 2/2] drm/panfrost: Add basic support for speed binning
On Fri, 31 Mar 2023 10:57:46 +0200
AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
wrote:

> Il 31/03/23 10:49, Boris Brezillon ha scritto:
> > On Fri, 31 Mar 2023 10:11:07 +0200
> > AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
> > wrote:
> >
> >> Il 23/03/23 10:08, AngeloGioacchino Del Regno ha scritto:
> >>> Some SoCs implementing ARM Mali GPUs are subject to speed binning:
> >>> this means that some versions of the same SoC model may need to be
> >>> limited to a slower frequency compared to the other:
> >>> this is being addressed by reading nvmem (usually, an eFuse array)
> >>> containing a number that identifies the speed binning of the chip,
> >>> which is usually related to silicon quality.
> >>>
> >>> To address such situation, add basic support for reading the
> >>> speed-bin through nvmem, as to make it possible to specify the
> >>> supported hardware in the OPP table for GPUs.
> >>> This commit also keeps compatibility with any platform that does
> >>> not specify (and does not even support) speed-binning.
> >>>
> >>> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
> >>
> >> Hello maintainers,
> >> I've seen that this got archived in the dri-devel patchwork; because of that and
> >> only that, I'm sending this ping to get this patch reviewed.
> >
> > Looks good to me. If you can get a DT maintainer to review the binding
> > (Rob?), I'd be happy to queue the series to drm-misc-next.
> >
>
> The binding was acked by Krzysztof already... so, just to be sure:
>
> Krzysztof, can the binding [1] get picked?

Oops, sorry, I didn't realize Krzysztof is a DT maintainer.

\
 
 \ /
  Last update: 2023-03-31 11:31    [W:0.042 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site