Messages in this thread | | | Date | Wed, 29 Mar 2023 09:24:38 +0200 | Subject | Re: [PATCH] dt-bindings: usb: typec-tcpci: convert to DT schema format | From | Krzysztof Kozlowski <> |
| |
On 29/03/2023 09:16, Jun Li wrote: > > Per spec below, TCPCI does need interrupt for alert, but no limit on the number. > > "The TCPC uses I2C to communicate with the TCPM. The TCPC is an I2C slave > with Alert# signal for requesting attention." > >> no supplies and no additional GPIOs (like reset >> GPIO)? > > Those are out of scope of spec, I think it can be added as optional. > >> >> Because this is what this binding is saying. >> >>> fully compliance with tcpci spec, if change it to be only specific to >>> nxp,ptn5110, my understanding is then other chips need duplicate a >>> binding doc even common tcpci binding and driver is enough for them. >> >> Depends. Usually we have common schema used by actual device schemas. If >> TCPCI-compliant device cannot have additional properties, > > My understanding was TCPCI-compliant device can have additional optional > properties.
Then I propose to rename it to device-matching name (nxp,ptn5110.yaml). Except interrupt and connector, there is nothing here which describes actual standard or common class. These can easily be moved to shared binding later. I can easily imagine TCPCI devices with a bit different interface and different properties.
Best regards, Krzysztof
| |