lkml.org 
[lkml]   [2023]   [Dec]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v1 1/8] dt-bindings: pinctrl: Add thead,th1520-pinctrl bindings
Linus Walleij wrote:
> On Sat, Dec 16, 2023 at 2:57 PM Emil Renner Berthing
> <emil.renner.berthing@canonical.com> wrote:
>
> > > > + thead,strong-pull-up:
> > > > + oneOf:
> > > > + - type: boolean
> > > > + - $ref: /schemas/types.yaml#/definitions/uint32
> > > > + enum: [ 0, 2100 ]
> > > > + description: Enable or disable strong 2.1kOhm pull-up.
> > >
> > > bias-pull-up can already specify the strength in Ohms.
> >
> > The strong pull up is a separate bit that can be enabled independently from the
> > regular pull-up/down, so in theory you could enable both the regular pull-up
> > and the strong pull-up at the same time, or even the regular poll-down and the
> > strong pull-up which is probably not advised.
>
> bias-pull-up; <- Just regular pulling up the ordinary
> bias-pull-up = <100>; <- Same thing if the ordinary is 100 Ohm (figure out what
> resistance it actually is....)
> bias-pull-up = <21000000>; <- strong pull up
> bias-pull-up = <21000100>; <- both at the same time

Hmm.. the two pull-ups combined would be a stronger pull-up, eg. lower
resistance, right? So you'd need to calculate it using
https://en.wikipedia.org/wiki/Series_and_parallel_circuits#Resistance_units_2

The problem is that the documentation doesn't actually mention what will happen
if you combine the strong pull-up with the regular bias. My best guess for what
happens if you enable the strong pull-up and the regular pull-down is that you
create a sort of voltage divider. But how do you represent that as an Ohm value?

We would kind of have to, otherwise the pinconf_get callbacks have states that
it can't represent.

> > So the idea here was just to make sure that you can do eg.
> >
> > thead,strong-pull-up = <0>;
> >
> > to make sure the bit is cleared.
>
> No use bias-disable; for this.
>
> Yours,
> Linus Walleij
>
> _______________________________________________
> linux-riscv mailing list
> linux-riscv@lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-riscv

\
 
 \ /
  Last update: 2023-12-21 13:30    [W:0.069 / U:0.320 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site