lkml.org 
[lkml]   [2023]   [Dec]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v1 0/2] w1: add UART w1 bus driver
From
On 21/12/2023 07:50, Christoph Winklhofer wrote:
> Hello!
>
> Krzysztof, thank your very much for your feedback!
>
> This patch contains a driver for a 1-Wire bus over UART. The driver
> utilizes the UART interface via the Serial Device Bus to create the
> 1-Wire timing patterns.
>
> Version 1
>

You already sent v1, so this is v2:

b4 diff '<20231221065049.30703-1-cj.winklhofer@gmail.com>'
Grabbing thread from
lore.kernel.org/all/20231221065049.30703-1-cj.winklhofer@gmail.com/t.mbox.gz
---
Analyzing 4 messages in the thread
ERROR: Could not auto-find previous revision
Run "b4 am -T" manually, then "b4 diff -m mbx1 mbx2"

I still cannot find the changelog. Does it mean nothing improved?


> - In v1, the driver requests a baud-rate (9600 for reset and 115200 for
> write/read) and tries to adapt the transmitted byte according to the
> actual baud-rate returned from serdev. Is this the correct direction or
> should the baud-rate be specified in the device-tree? Alternatively,
> it could make sense to specify the minimum and maximum times for the
> 1-Wire operations in the device-tree, instead of using hard-coded ones
> similar as in "Figure 11. Configuration tab" of the linked document
> "Using UART to Implement a 1-Wire Bus Master".

Depends, are these hardware properties? Are these runtime? What do they
depend on?

>
> - In addition, the received byte is now protected with a mutex - instead
> of the atomic, which I used before due to the concurrent store and load.
>
> - Receiving more than one byte results in an error, since the w1-uart
> driver is the only writer, it writes a single-byte and should receive
> a single byte.
>
> Changes:
> - support different baud-rates
> - fix variable names, errno-returns, wrong define CONFIG_OF
> - fix log flooding
> - fix locking problem for serdev-receive and w1-master reset/touch
> - fix driver remove (error-path for rxtx-function)
> - add documentation for dt-binding

So this looks like changelog. Please make it explicit - move it to the
beginning of cover letter and say "changes in v2".


Best regards,
Krzysztof


\
 
 \ /
  Last update: 2023-12-21 22:13    [W:2.038 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site