lkml.org 
[lkml]   [2023]   [Nov]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/2] dt-bindings: serial: rs485: add rs485-mux-gpios binding
From
On 21/11/2023 09:27, Rasmus Villemoes wrote:
> On 21/11/2023 08.52, Krzysztof Kozlowski wrote:
>> On 20/11/2023 16:10, Rasmus Villemoes wrote:
>>> Some boards are capable of both rs232 and rs485, and control which
>>> external terminals are active via a gpio-controlled mux. Allow
>>> describing that gpio in DT so that the kernel can transparently handle
>>> the proper setting when the uart is switched between rs232 and rs485
>>> modes.
>>>
>>> Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk>
>>> ---
>>> Documentation/devicetree/bindings/serial/rs485.yaml | 5 +++++
>>> 1 file changed, 5 insertions(+)
>>>
>>> diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
>>> index 9418fd66a8e9..e8136c7d22ed 100644
>>> --- a/Documentation/devicetree/bindings/serial/rs485.yaml
>>> +++ b/Documentation/devicetree/bindings/serial/rs485.yaml
>>> @@ -61,6 +61,11 @@ properties:
>>> the active state enables RX during TX.
>>> maxItems: 1
>>>
>>> + rs485-mux-gpios:
>>> + description: GPIO pin to control muxing of the SOC signals to the RS485
>>> + transceiver.
>>> + maxItems: 1
>>
>> Aren't you duplicating
>> https://lore.kernel.org/all/3Nk.ZZrp.5w3Yn0Ecy5C.1bMzDp@seznam.cz/ ?
>
> Hadn't seen that, but no, this is not at all the same. That patch seems
> to define an input pin to tell whether to enable rs485 mode or not (sort
> of early run-time version of the linux,rs485-enabled-at-boot-time).
>
>> Anyway, similar comments: this does not look like generic RS485
>> property. Are you saying that standard defines such GPIO?
>
> No, I'm saying that several boards that exist in the wild have the
> RX/TX/CTS etc. pins routed to a multiplexer, which in turn routes those
> signals to either a rs485 transceiver or an rs232 driver (and those in
> turn are connected to different screw terminals). So no, it's not a
> property of the rs485 protocol itself, but very much related to making
> use of rs485 (and rs232, though of course not simultaneously) on such
> boards.

Which upstream boards use it? To me it looks like specific to each
controller, not to RS485.

>
> Would a link to a schematic help?

Yes, always :)

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2023-11-21 09:34    [W:0.057 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site