lkml.org 
[lkml]   [2023]   [Oct]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v5 2/2] leds: ledtrig-tty: add new line mode evaluation


On 2023-10-23 14:27, Greg KH wrote:
> On Mon, Oct 23, 2023 at 02:15:55PM +0200, Florian Eckert wrote:
>> > Again, I thought we had rx/tx already? If not, how was that controlled
>> > today?
>>
>> It could not be controlled! The LED flashed when data where
>> transferred.
>> This was the only function that the trigger supported.
>
> Ok, then maybe this needs to be a bit longer of a series. One that
> does
> the "tx/rx" feature, as that is needed today, and will be the more
> complex one, and then one-per-line-setting that you want to apply.
>
> That should make it much easier to review overall, right?

Sorry for asking, but why should I split the change.
What is the added value? But if it is necessary, then I will do it.

Before my change, the trigger could not be configured.
The LED always flashed when data was transferred.
Now I can configure for which tty event the LED should flash or be
on/off.
So that the trigger behaves the same as before (flash on rx/tx
transmission),
I set the rx/tx bits in the function ledtrig_tty_activate() with the
following code. Nothing changes for the user of the trigger.

/* Enable default rx/tx LED blink */
set_bit(TRIGGER_TTY_TX, &trigger_data->ttytrigger);
set_bit(TRIGGER_TTY_RX, &trigger_data->ttytrigger);

---
Florian

\
 
 \ /
  Last update: 2023-10-23 14:46    [W:0.051 / U:0.220 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site