lkml.org 
[lkml]   [2023]   [Oct]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v11 13/13] arm64: dts: qcom: sa8540-ride: Enable first port of tertiary usb controller
From


On 9/14/23 17:45, Krishna Kurapati PSSNV wrote:
>
>
> On 9/13/2023 5:40 PM, Konrad Dybcio wrote:
>> On 7.09.2023 05:36, Krishna Kurapati PSSNV wrote:
>>>
>>>
>>>> Is there any benefit to removing the other ports?
>>>>
>>>> i.e. are ports 1-3 not parked properly by the dwc3 driver if
>>>> they're never connected to anything?
>>>>
>>> Hi Konrad,
>>>
>>>   Whether or not the phy is connected to a port, the controller would
>>> modify the GUSB2PHYCFG/GUSB3PIPECTL registers. But if we don't
>>> specify only one phy and let phys from base DTSI take effect (4 HS /
>>> 2 SS), we would end up initializing and powering on phy's which are
>>> never connected to a port. To avoid that we need to specify only one
>>> phy for this platform.
>> And does that have any major effect on power use?
>>
>> Do these PHYs not have some dormant/low power mode?
>>
> Hi Konrad,
>
>  I believe there will be some minimal power use. IMO its best to keep
> only one phy enabled for this variant instead of giving all and
> initializing/powering-on all 4 of them.
Okay let's not waste power..

Konrad

\
 
 \ /
  Last update: 2023-10-02 11:48    [W:0.204 / U:0.120 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site