lkml.org 
[lkml]   [2023]   [Oct]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] x86/efistub: Don't try to print after ExitBootService()
On Wed, Oct 11, 2023 at 10:25:28PM +0300, Nikolay Borisov wrote:
> setup_e820() is executed after UEFI's ExitBootService has been called.
> This causes the firmware to throw an exception because Console IO
> protocol handler is supposed to work only during boot service
> environment. As per UEFI 2.9, section 12.1:
>
> "This protocol isused to handle input and output of text-based
> information intended for the system user during the operation of code
> in the boot services environment."
>
> Running a TDX guest with TDVF with unaccepted memory disabled results in
> the following output:

Oh. My bad.

But there's other codepath that does the same. If setup_e820() fails with
EFI_BUFFER_TOO_SMALL, efi_stub_entry() would try to print "exit_boot()
failed\n".

I wouldner if it is feasible to hook up earlyprintk console into
efi_printk() machinery for after ExitBootService() case? Silent boot
failure is not the best UX.

--
Kiryl Shutsemau / Kirill A. Shutemov

\
 
 \ /
  Last update: 2023-10-12 12:15    [W:0.138 / U:0.440 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site