lkml.org 
[lkml]   [2023]   [Jan]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRE: [PATCH 4/5] gpio: Add support for Renesas RZ/V2M PWC
Date
Hi Bartosz,

Thanks for your feedback!

>
> On Tue, Dec 13, 2022 at 11:43 PM Fabrizio Castro
> <fabrizio.castro.jz@renesas.com> wrote:
> >
> > The RZ/V2M SoC contains an External Power Sequence Controller (PWC)
> > module. This module provides an external power supply on/off sequence,
> > on/off signal for the LPDDR4 core power supply, control signals for
> > external I/O power supplies of the SD host interfaces, and key input
> > signals.
> > PWC is essentially a Multi-Function Device (MFD).
> >
> > The driver just implements the control signals for external I/O
> > power supplies of the SD host interfaces as gpios, and it relies on
> > syscon and simple-mfd.
> >
> > Signed-off-by: Phil Edworthy <phil.edworthy@renesas.com>
> > Signed-off-by: Fabrizio Castro <fabrizio.castro.jz@renesas.com>
> > ---
> > drivers/gpio/Kconfig | 8 +++
> > drivers/gpio/Makefile | 1 +
> > drivers/gpio/gpio-rzv2m-pwc.c | 123 ++++++++++++++++++++++++++++++++++
> > 3 files changed, 132 insertions(+)
> > create mode 100644 drivers/gpio/gpio-rzv2m-pwc.c
> >
> > diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
> > index e6ebc4c90a5d..e016919b9643 100644
> > --- a/drivers/gpio/Kconfig
> > +++ b/drivers/gpio/Kconfig
> > @@ -553,6 +553,14 @@ config GPIO_ROCKCHIP
> > help
> > Say yes here to support GPIO on Rockchip SoCs.
> >
> > +config GPIO_RZV2M_PWC
> > + tristate "Renesas RZ/V2M PWC GPIO support"
> > + depends on MFD_SYSCON
> > + depends on ARCH_R9A09G011 || COMPILE_TEST
> > + help
> > + Say yes here to support the External Power Sequence Controller
> (PWC)
> > + GPIO controller driver for RZ/V2M devices.
> > +
> > config GPIO_SAMA5D2_PIOBU
> > tristate "SAMA5D2 PIOBU GPIO support"
> > depends on MFD_SYSCON
> > diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
> > index 3462a138764a..5f655684603f 100644
> > --- a/drivers/gpio/Makefile
> > +++ b/drivers/gpio/Makefile
> > @@ -132,6 +132,7 @@ obj-$(CONFIG_GPIO_RDC321X) += gpio-
> rdc321x.o
> > obj-$(CONFIG_GPIO_REALTEK_OTTO) += gpio-realtek-otto.o
> > obj-$(CONFIG_GPIO_REG) += gpio-reg.o
> > obj-$(CONFIG_GPIO_ROCKCHIP) += gpio-rockchip.o
> > +obj-$(CONFIG_GPIO_RZV2M_PWC) += gpio-rzv2m-pwc.o
> > obj-$(CONFIG_ARCH_SA1100) += gpio-sa1100.o
> > obj-$(CONFIG_GPIO_SAMA5D2_PIOBU) += gpio-sama5d2-piobu.o
> > obj-$(CONFIG_GPIO_SCH311X) += gpio-sch311x.o
> > diff --git a/drivers/gpio/gpio-rzv2m-pwc.c b/drivers/gpio/gpio-rzv2m-
> pwc.c
> > new file mode 100644
> > index 000000000000..672d868cb8c9
> > --- /dev/null
> > +++ b/drivers/gpio/gpio-rzv2m-pwc.c
> > @@ -0,0 +1,123 @@
> > +// SPDX-License-Identifier: GPL-2.0-only
> > +/*
> > + * Copyright (C) 2022 Renesas Electronics Corporation
> > + *
> > + * GPIO driver for Renesas RZ/V2M External Power Sequence Controller
> (PWC)
> > + */
> > +
> > +#include <linux/gpio/driver.h>
> > +#include <linux/mfd/syscon.h>
> > +#include <linux/platform_device.h>
> > +#include <linux/regmap.h>
> > +#include <linux/spinlock.h>
> > +
> > +struct rzv2m_pwc_gpio_priv {
> > + struct gpio_chip gp;
> > + int offset;
> > + struct regmap *regmap;
> > + DECLARE_BITMAP(ch_en_bits, 2);
> > +};
> > +
> > +static void rzv2m_pwc_gpio_set(struct gpio_chip *chip, unsigned int
> offset,
> > + int value)
> > +{
> > + struct rzv2m_pwc_gpio_priv *priv = gpiochip_get_data(chip);
> > + u32 reg;
> > +
> > + /* BIT 16 enables write to BIT 0, and BIT 17 enables write to
> BIT 1 */
> > + reg = BIT(offset + 16);
> > + if (value)
> > + reg |= BIT(offset);
> > +
> > + regmap_write(priv->regmap, priv->offset, reg);
> > +
> > + if (value)
> > + set_bit(offset, priv->ch_en_bits);
> > + else
> > + clear_bit(offset, priv->ch_en_bits);
>
> You can use assign_bit() here and pass value to it.

Good point, I will fix it in v3.

>
> > +}
> > +
> > +static int rzv2m_pwc_gpio_get(struct gpio_chip *chip, unsigned int
> offset)
> > +{
> > + struct rzv2m_pwc_gpio_priv *priv = gpiochip_get_data(chip);
> > +
> > + return test_bit(offset, priv->ch_en_bits);
> > +}
> > +
> > +static int rzv2m_pwc_gpio_direction_output(struct gpio_chip *gc,
> > + unsigned int nr, int value)
> > +{
> > + if (nr > 1)
> > + return -EINVAL;
> > +
> > + rzv2m_pwc_gpio_set(gc, nr, value);
> > +
> > + return 0;
> > +}
> > +
> > +static const struct gpio_chip rzv2m_pwc_gc = {
> > + .label = "rzv2m_pwc_gpio",
> > + .owner = THIS_MODULE,
> > + .get = rzv2m_pwc_gpio_get,
> > + .set = rzv2m_pwc_gpio_set,
> > + .direction_output = rzv2m_pwc_gpio_direction_output,
> > + .can_sleep = false,
> > + .ngpio = 2,
> > + .base = -1,
> > +};
> > +
> > +static int rzv2m_pwc_gpio_probe(struct platform_device *pdev)
> > +{
> > + struct rzv2m_pwc_gpio_priv *priv;
> > + int err;
> > +
> > + priv = devm_kzalloc(&pdev->dev, sizeof(*priv), GFP_KERNEL);
> > + if (!priv)
> > + return -ENOMEM;
> > +
> > + priv->regmap = syscon_regmap_lookup_by_phandle(pdev-
> >dev.of_node,
> > + "regmap");
> > +
> > + if (IS_ERR(priv->regmap))
> > + return dev_err_probe(&pdev->dev, PTR_ERR(priv->regmap),
> > + "Can't find regmap property");
> > +
> > + err = of_property_read_u32(pdev->dev.of_node, "offset", &priv-
> >offset);
>
> Please don't use OF APIs in drivers anymore, use
> device_property_read_u32() instead.


Gotcha, I'll fix it in v3.

Thanks!
Fab

>
> Otherwise looks pretty good!
>
> Bart
>
> > + if (err)
> > + return dev_err_probe(&pdev->dev, -EINVAL,
> > + "Can't find offset property");
> > +
> > + /*
> > + * The register used by this driver cannot be read, therefore
> set the
> > + * outputs to their default values and initialize priv-
> >ch_en_bits accordingly.
> > + * BIT 16 enables write to BIT 0, BIT 17 enables write to BIT 1,
> and the
> > + * default value of both BIT 0 and BIT 1 is 0.
> > + */
> > + regmap_write(priv->regmap, priv->offset, BIT(17) | BIT(16));
> > + bitmap_zero(priv->ch_en_bits, 2);
> > +
> > + priv->gp = rzv2m_pwc_gc;
> > + priv->gp.parent = pdev->dev.parent;
> > + priv->gp.fwnode = dev_fwnode(&pdev->dev);
> > +
> > + return devm_gpiochip_add_data(&pdev->dev, &priv->gp, priv);
> > +}
> > +
> > +static const struct of_device_id rzv2m_pwc_gpio_of_match[] = {
> > + { .compatible = "renesas,rzv2m-pwc-gpio" },
> > + { /* sentinel */ }
> > +};
> > +MODULE_DEVICE_TABLE(of, rzv2m_pwc_gpio_of_match);
> > +
> > +static struct platform_driver rzv2m_pwc_gpio_driver = {
> > + .probe = rzv2m_pwc_gpio_probe,
> > + .driver = {
> > + .name = "rzv2m_pwc_gpio",
> > + .of_match_table = of_match_ptr(rzv2m_pwc_gpio_of_match),
> > + },
> > +};
> > +module_platform_driver(rzv2m_pwc_gpio_driver);
> > +
> > +MODULE_LICENSE("GPL");
> > +MODULE_AUTHOR("Fabrizio Castro <castro.fabrizio.jz@renesas.com>");
> > +MODULE_DESCRIPTION("Renesas RZ/V2M PWC GPIO");
> > --
> > 2.34.1
> >
\
 
 \ /
  Last update: 2023-03-26 23:29    [W:0.051 / U:24.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site