lkml.org 
[lkml]   [2023]   [Jan]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 3/4] pinctrl: bcm2835: Switch to use ->add_pin_ranges()
Date
Yeah, while the ->add_pin_ranges() shouldn't be used by DT drivers,
this one requires it to support quite old firmware descriptions that
do not have gpio-ranges property.

The change allows to clean up GPIO library from OF specifics.
There is no functional change intended.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
drivers/pinctrl/bcm/pinctrl-bcm2835.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/pinctrl/bcm/pinctrl-bcm2835.c b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
index c7cdccdb4332..8e2551a08c37 100644
--- a/drivers/pinctrl/bcm/pinctrl-bcm2835.c
+++ b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
@@ -358,9 +358,9 @@ static int bcm2835_gpio_direction_output(struct gpio_chip *chip,
return 0;
}

-static int bcm2835_of_gpio_ranges_fallback(struct gpio_chip *gc,
- struct device_node *np)
+static int bcm2835_add_pin_ranges_fallback(struct gpio_chip *gc)
{
+ struct device_node *np = dev_of_node(gc->parent);
struct pinctrl_dev *pctldev = of_pinctrl_get(np);

if (!pctldev)
@@ -386,7 +386,7 @@ static const struct gpio_chip bcm2835_gpio_chip = {
.base = -1,
.ngpio = BCM2835_NUM_GPIOS,
.can_sleep = false,
- .of_gpio_ranges_fallback = bcm2835_of_gpio_ranges_fallback,
+ .add_pin_ranges = bcm2835_add_pin_ranges_fallback,
};

static const struct gpio_chip bcm2711_gpio_chip = {
@@ -403,7 +403,7 @@ static const struct gpio_chip bcm2711_gpio_chip = {
.base = -1,
.ngpio = BCM2711_NUM_GPIOS,
.can_sleep = false,
- .of_gpio_ranges_fallback = bcm2835_of_gpio_ranges_fallback,
+ .add_pin_ranges = bcm2835_add_pin_ranges_fallback,
};

static void bcm2835_gpio_irq_handle_bank(struct bcm2835_pinctrl *pc,
--
2.39.0
\
 
 \ /
  Last update: 2023-03-26 23:41    [W:1.609 / U:0.004 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site