lkml.org 
[lkml]   [2022]   [Sep]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v2 3/5] arm64: dts: qcom: Add PM6125 PMIC
From
On 07/09/2022 23:27, Marijn Suijten wrote:
> On 2022-08-08 12:17:06, Krzysztof Kozlowski wrote:
>> On 05/08/2022 16:57, Marijn Suijten wrote:
>>> This PMIC is commonly used on boards with an SM6125 SoC and looks very
>>> similar in layout to the PM6150.
>>>
>>> Downstream declares more nodes to be available, but these have been
>>> omitted from this patch: the pwm/lpg block is unused on my reference
>>> device making it impossible to test/validate, and the spmi-clkdiv does
>>> not have a single device-tree binding using this driver yet, hence
>>> inclusion is better postponed until ie. audio which uses these clocks is
>>> brought up.
>>>
>>
>> Thank you for your patch. There is something to discuss/improve.
>
> I can respin the series with the suggested changes (and the iio patch
> removed as that has now been applied), but note that all other PMIC dtsi
> files as of -next today still carry the "wrong" adc-tm or gpios node
> names. Are there plans to patch those up too (if not already in a
> series that I missed)?

See below

>
> - Marijn
>
>>> +
>>> + xo-therm@4c {
>>> + reg = <ADC5_XO_THERM_100K_PU>;
>>> + qcom,pre-scaling = <1 1>;
>>> + qcom,hw-settle-time = <200>;
>>> + qcom,ratiometric;
>>> + };
>>> + };
>>> +
>>> + pm6125_adc_tm: adc-tm@3500 {
>>
>> Generic node names, so either this is adc or thermal-sensor. Looks like
>> thermal-sensor.

My comment was here not correct. The schema indeed expects this to be
adc-tm. I did not plan to change it, so let's keep adc-tm also here.

>>
>>> + compatible = "qcom,spmi-adc-tm5";
>>> + reg = <0x3500>;
>>> + interrupts = <0x0 0x35 0x0 IRQ_TYPE_EDGE_RISING>;
>>> + #address-cells = <1>;
>>> + #size-cells = <0>;
>>> + #thermal-sensor-cells = <1>;
>>> + status = "disabled";
>>> + };
>>> +
>>> + pm6125_rtc: rtc@6000 {
>>> + compatible = "qcom,pm8941-rtc";
>>> + reg = <0x6000>, <0x6100>;
>>> + reg-names = "rtc", "alarm";
>>> + interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
>>> + status = "disabled";
>>> + };
>>> +
>>> + pm6125_gpio: gpios@c000 {
>>
>> s/gpios/gpio/

Both are allowed by schema, but convention in all other cases is "gpio",
so let's change it. I'll send a patch for other files.

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-09-08 09:28    [W:0.087 / U:0.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site