lkml.org 
[lkml]   [2022]   [Sep]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 1/3] iommu/s390: Fix duplicate domain attachments
From
Date
On Mon, 2022-09-26 at 10:51 -0300, Jason Gunthorpe wrote:
> On Mon, Sep 26, 2022 at 03:29:49PM +0200, Niklas Schnelle wrote:
> > I did miss a problem in my initial answer. While zpci_register_ioat()
> > is indeed the actual "attach" operation, it assumes that at that point
> > no DMA address translations are registered. In that state DMA is
> > blocked of course. With that zpci_register_ioat() needs to come after
> > the zpci_unregister_ioat() that is part of __s390_iommu_detach_device()
> > and zpci_dma_exit_device(). If we do call those though we fundamentally
> > need to restore the previous domain / DMA API state on any subsequent
> > failure. If we don't restore we would leave the device detached from
> > any domain with DMA blocked. I wonder if this could be an acceptable
> > failure state though? It's safe as no DMA is possible and we could get
> > out of it with a successful attach.
>
> Is this because of that FW call it does?
>
> It seems like an FW API misdesign to not allow an unfailable change of
> translation, if the FW forces an unregister first then there are
> always error cases you can't correctly recover from.
>
> IMHO if the FW fails an attach you are just busted, there is no reason
> to think it would suddenly accept attaching the old domain just
> because it has a different physical address, right?

While I can't come up with a case where an immediate retry would
actually help, there is at least one error case that one should be able
to recover from. The attach can fail if a firmware driven PCI device
recovery is in progress. Now if that happens during a switch between
domains I think one will have to do the equivalent of

echo 0 > /sys/bus/pci/slots/<dev>/power; echo 1 > /.../power

That of course tears down the whole PCI device so we don't have to
answer the question if the old or new domain is the active one.

So I think in the consequences you're still right, attempting to re-
attach is a lot of hassle for little or no gain.

>
> So make it simple, leave it DMA blocked and throw a WARN_ON..

To me a WARN_ON() isn't appropriate here, as stated above there is at
least one error case that is recoverable and doesn't necessarily
indicate a progamming bug. Also while not recoverable the device having
been surprise unplugged is another case where the attach failing is not
necessarily a bug. It would also thus cause false panics for e.g. CI
systems with PANIC_ON_WARN.

That said yes I think leaving DMA blocked and the device detached from
any domain is reasonable. That way the above recover scenario will work
and the device is in a defined and isolated state. Maybe in the future
we could even make this explicit and attach to the blocking domain on
failed attach, does that make sense?

\
 
 \ /
  Last update: 2022-09-27 18:26    [W:0.048 / U:2.236 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site