lkml.org 
[lkml]   [2022]   [Sep]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 5.19 048/207] efi: x86: Wipe setup_data on pure EFI boot
Date
From: Ard Biesheuvel <ardb@kernel.org>

commit 63bf28ceb3ebbe76048c3fb2987996ca1ae64f83 upstream.

When booting the x86 kernel via EFI using the LoadImage/StartImage boot
services [as opposed to the deprecated EFI handover protocol], the setup
header is taken from the image directly, and given that EFI's LoadImage
has no Linux/x86 specific knowledge regarding struct bootparams or
struct setup_header, any absolute addresses in the setup header must
originate from the file and not from a prior loading stage.

Since we cannot generally predict where LoadImage() decides to load an
image (*), such absolute addresses must be treated as suspect: even if a
prior boot stage intended to make them point somewhere inside the
[signed] image, there is no way to validate that, and if they point at
an arbitrary location in memory, the setup_data nodes will not be
covered by any signatures or TPM measurements either, and could be made
to contain an arbitrary sequence of SETUP_xxx nodes, which could
interfere quite badly with the early x86 boot sequence.

(*) Note that, while LoadImage() does take a buffer/size tuple in
addition to a device path, which can be used to provide the image
contents directly, it will re-allocate such images, as the memory
footprint of an image is generally larger than the PE/COFF file
representation.

Cc: <stable@vger.kernel.org> # v5.10+
Link: https://lore.kernel.org/all/20220904165321.1140894-1-Jason@zx2c4.com/
Signed-off-by: Ard Biesheuvel <ardb@kernel.org>
Acked-by: Jason A. Donenfeld <Jason@zx2c4.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/firmware/efi/libstub/x86-stub.c | 7 +++++++
1 file changed, 7 insertions(+)

--- a/drivers/firmware/efi/libstub/x86-stub.c
+++ b/drivers/firmware/efi/libstub/x86-stub.c
@@ -517,6 +517,13 @@ efi_status_t __efiapi efi_pe_entry(efi_h
hdr->ramdisk_image = 0;
hdr->ramdisk_size = 0;

+ /*
+ * Disregard any setup data that was provided by the bootloader:
+ * setup_data could be pointing anywhere, and we have no way of
+ * authenticating or validating the payload.
+ */
+ hdr->setup_data = 0;
+
efi_stub_entry(handle, sys_table_arg, boot_params);
/* not reached */


\
 
 \ /
  Last update: 2022-09-26 13:38    [W:0.528 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site