lkml.org 
[lkml]   [2022]   [Sep]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [RESEND PATCH V5 6/7] ublk_drv: add START_USER_RECOVERY and END_USER_RECOVERY support
On Fri, Sep 23, 2022 at 02:15:04PM +0800, ZiyangZhang wrote:
> START_USER_RECOVERY and END_USER_RECOVERY are two new control commands
> to support user recovery feature.
>
> After a crash, user should send START_USER_RECOVERY, it will:
> (1) check if (a)current ublk_device is UBLK_S_DEV_QUIESCED which was
> set by quiesce_work and (b)chardev is released
> (2) reinit all ubqs, including:
> (a) put the task_struct and reset ->ubq_daemon to NULL.
> (b) reset all ublk_io.
> (3) reset ub->mm to NULL.
>
> Then, user should start a new process and send FETCH_REQ on each
> ubq_daemon.
>
> Finally, user should send END_USER_RECOVERY, it will:
> (1) wait for all new ubq_daemons getting ready.
> (2) update ublksrv_pid
> (3) unquiesce the request queue and expect incoming ublk_queue_rq()
> (4) convert ub's state to UBLK_S_DEV_LIVE
>
> Note: we can handle STOP_DEV between START_USER_RECOVERY and
> END_USER_RECOVERY. This is helpful to users who cannot start new process
> after sending START_USER_RECOVERY ctrl-cmd.
>
> Signed-off-by: ZiyangZhang <ZiyangZhang@linux.alibaba.com>

Reviewed-by: Ming Lei <ming.lei@redhat.com>

Thanks,
Ming

\
 
 \ /
  Last update: 2022-09-23 15:51    [W:0.081 / U:0.388 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site