lkml.org 
[lkml]   [2022]   [Sep]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] gpiolib: cdev: Set lineevent_state::irq after IRQ register successfully
On Wed, Sep 21, 2022 at 11:52:31AM +0800, Kent Gibson wrote:
> On Wed, Sep 21, 2022 at 11:20:20AM +0800, Meng Li wrote:
> > When running gpio test on nxp-ls1028 platform with below command
> > gpiomon --num-events=3 --rising-edge gpiochip1 25
> > There will be a warning trace as below:
> > Call trace:
> > free_irq+0x204/0x360
> > lineevent_free+0x64/0x70
> > gpio_ioctl+0x598/0x6a0
> > __arm64_sys_ioctl+0xb4/0x100
> > invoke_syscall+0x5c/0x130
> > ......
> > el0t_64_sync+0x1a0/0x1a4
> > The reason of this issue is that calling request_threaded_irq()
> > function failed, and then lineevent_free() is invoked to release
> > the resource. Since the lineevent_state::irq was already set, so
> > the subsequent invocation of free_irq() would trigger the above
> > warning call trace. To fix this issue, set the lineevent_state::irq
> > after the IRQ register successfully.
> >
> > Fixes: 468242724143 ("gpiolib: cdev: refactor lineevent cleanup into lineevent_free")
> > Cc: stable@vger.kernel.org
> > Signed-off-by: Meng Li <Meng.Li@windriver.com>
>
> Good pick up - the IRQ shouldn't be freed if it hasn't been successfully requested.
>
> Signed-off-by: Kent Gibson <warthog618@gmail.com>
>

Oops, that should be

Reviewed-by: Kent Gibson <warthog618@gmail.com>

\
 
 \ /
  Last update: 2022-09-21 08:41    [W:0.043 / U:0.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site