lkml.org 
[lkml]   [2022]   [Sep]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH net-next] net: lan966x: Extend lan966x with RGMII support
Hello Horatiu,

On Thu, 1 Sep 2022 14:23:46 +0200
Horatiu Vultur <horatiu.vultur@microchip.com> wrote:

> Extend lan966x with RGMII support. The MAC supports all RGMII_* modes.
>
> Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
> ---
> drivers/net/ethernet/microchip/lan966x/lan966x_main.c | 8 ++++++++
> drivers/net/ethernet/microchip/lan966x/lan966x_phylink.c | 3 +++
> 2 files changed, 11 insertions(+)
>
> diff --git a/drivers/net/ethernet/microchip/lan966x/lan966x_main.c
> b/drivers/net/ethernet/microchip/lan966x/lan966x_main.c index
> 1d6e3b641b2e..e2d250ed976b 100644 ---
> a/drivers/net/ethernet/microchip/lan966x/lan966x_main.c +++
> b/drivers/net/ethernet/microchip/lan966x/lan966x_main.c @@ -772,6
> +772,14 @@ static int lan966x_probe_port(struct lan966x *lan966x, u32
> p, __set_bit(PHY_INTERFACE_MODE_MII,
> port->phylink_config.supported_interfaces);
> + __set_bit(PHY_INTERFACE_MODE_RGMII,
> + port->phylink_config.supported_interfaces);
> + __set_bit(PHY_INTERFACE_MODE_RGMII_ID,
> + port->phylink_config.supported_interfaces);
> + __set_bit(PHY_INTERFACE_MODE_RGMII_RXID,
> + port->phylink_config.supported_interfaces);
> + __set_bit(PHY_INTERFACE_MODE_RGMII_TXID,
> + port->phylink_config.supported_interfaces);

Instead of defining each individual variant, you can use :

phy_interface_set_rgmii(port->phylink_config.supported_interfaces);

> __set_bit(PHY_INTERFACE_MODE_GMII,
> port->phylink_config.supported_interfaces);
> __set_bit(PHY_INTERFACE_MODE_SGMII,
> diff --git a/drivers/net/ethernet/microchip/lan966x/lan966x_phylink.c
> b/drivers/net/ethernet/microchip/lan966x/lan966x_phylink.c index
> 38a7e95d69b4..fb6aee509656 100644 ---
> a/drivers/net/ethernet/microchip/lan966x/lan966x_phylink.c +++
> b/drivers/net/ethernet/microchip/lan966x/lan966x_phylink.c @@ -59,6
> +59,9 @@ static void lan966x_phylink_mac_link_up(struct
> phylink_config *config, port_config->pause |= tx_pause ? MLO_PAUSE_TX
> : 0; port_config->pause |= rx_pause ? MLO_PAUSE_RX : 0;
> + if (phy_interface_mode_is_rgmii(interface))
> + phy_set_speed(port->serdes, speed);
> +
> lan966x_port_config_up(port);
> }
>

Best regards,

Maxime

\
 
 \ /
  Last update: 2022-09-01 17:38    [W:0.035 / U:0.492 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site