lkml.org 
[lkml]   [2022]   [Aug]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v1 1/2] spi: stm32-qspi: Replace of_gpio_named_count() by gpiod_count()
Date
As a preparation to unexport of_gpio_named_count(), convert the
driver to use gpiod_count() instead.

Signed-off-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
---
drivers/spi/spi-stm32-qspi.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/spi-stm32-qspi.c b/drivers/spi/spi-stm32-qspi.c
index 227f450aa5f0..5858f5f9c758 100644
--- a/drivers/spi/spi-stm32-qspi.c
+++ b/drivers/spi/spi-stm32-qspi.c
@@ -656,7 +656,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
mode = spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL);
if ((mode == SPI_TX_OCTAL || mode == SPI_RX_OCTAL) ||
((mode == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
- of_gpio_named_count(qspi->dev->of_node, "cs-gpios") == -ENOENT)) {
+ gpiod_count(qspi->dev, "cs") == -ENOENT)) {
dev_err(qspi->dev, "spi-rx-bus-width\\/spi-tx-bus-width\\/cs-gpios\n");
dev_err(qspi->dev, "configuration not supported\n");

@@ -681,7 +681,7 @@ static int stm32_qspi_setup(struct spi_device *spi)
* are both set in spi->mode and "cs-gpios" properties is found in DT
*/
if (((spi->mode & (SPI_TX_OCTAL | SPI_RX_OCTAL)) == (SPI_TX_OCTAL | SPI_RX_OCTAL)) &&
- of_gpio_named_count(qspi->dev->of_node, "cs-gpios")) {
+ gpiod_count(qspi->dev, "cs")) {
qspi->cr_reg |= CR_DFM;
dev_dbg(qspi->dev, "Dual flash mode enable");
}
--
2.35.1
\
 
 \ /
  Last update: 2022-08-30 20:29    [W:0.059 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site