lkml.org 
[lkml]   [2022]   [Aug]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v1 1/1] usb: phy: mxs: apply board calibration value base on chip trim value
From
On 30/08/2022 19:25, Frank Li wrote:
> USBPHY_TRIM_OVERRIDE provide chip trim value. DTS provide board level
> calibration data. Board level calibration data should be base on chip
> trim value.
>
> For example, TXCAL45DP board level hope add +2.85% register base on
> standard 45ohm. But chip trim value is -5.25% to get 45ohm output.
> Actually finial TXCAL45DP should be -5.25% + 2.85% = -2.4%.
>
> If chip have not trim value at USBPHY_TRIM_OVERRIDE, No behavior change.
> board level calibration will be applied.
>
> If chip have trim value at USBPHY_TRIM_OVERRIDE and no DTS board level
> data, chip trim value will be applied.
>
> Signed-off-by: Frank Li <Frank.Li@nxp.com>
> ---
> drivers/usb/phy/phy-mxs-usb.c | 40 ++++++++++++++++++++++++++++++++---
> 1 file changed, 37 insertions(+), 3 deletions(-)

Use scripts/get_maintainers.pl to CC all maintainers and relevant
mailing lists.... and do not Cc unrelated folks.

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2022-08-30 19:42    [W:0.043 / U:0.544 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site