Messages in this thread Patch in this message | | | From | Cristian Marussi <> | Subject | [PATCH v2 4/9] firmware: arm_scmi: Add xfer raw helpers | Date | Thu, 25 Aug 2022 15:11:47 +0100 |
| |
Add a few SCMI helpers useful to implement SCMI Raw access support.
Signed-off-by: Cristian Marussi <cristian.marussi@arm.com> --- v1 --> v2 - added scmi_xfer_raw_channel_get --- drivers/firmware/arm_scmi/common.h | 9 +++ drivers/firmware/arm_scmi/driver.c | 101 +++++++++++++++++++++++++++++ 2 files changed, 110 insertions(+)
diff --git a/drivers/firmware/arm_scmi/common.h b/drivers/firmware/arm_scmi/common.h index 096b66442d84..6d2a57a696d8 100644 --- a/drivers/firmware/arm_scmi/common.h +++ b/drivers/firmware/arm_scmi/common.h @@ -212,6 +212,15 @@ struct scmi_desc { const bool atomic_enabled; }; +void scmi_xfer_raw_put(const struct scmi_handle *handle, + struct scmi_xfer *xfer); +struct scmi_xfer *scmi_xfer_raw_get(const struct scmi_handle *handle); +struct scmi_chan_info * +scmi_xfer_raw_channel_get(const struct scmi_handle *handle, u8 protocol_id); + +int scmi_xfer_raw_inflight_register(const struct scmi_handle *handle, + struct scmi_xfer *xfer); + #ifdef CONFIG_ARM_SCMI_TRANSPORT_MAILBOX extern const struct scmi_desc scmi_mailbox_desc; #endif diff --git a/drivers/firmware/arm_scmi/driver.c b/drivers/firmware/arm_scmi/driver.c index 56b1a917f618..a49d9eaa1c09 100644 --- a/drivers/firmware/arm_scmi/driver.c +++ b/drivers/firmware/arm_scmi/driver.c @@ -350,6 +350,53 @@ scmi_xfer_inflight_register_unlocked(struct scmi_xfer *xfer, xfer->pending = true; } +/** + * scmi_xfer_inflight_register - Try to register an xfer as in-flight + * + * @xfer: The xfer to register + * @minfo: Pointer to Tx/Rx Message management info based on channel type + * + * Note that this helper does NOT assume anything about the sequence number + * that was baked into the provided xfer, so it checks at first if it can + * be mapped to a free slot and fails with an error if another xfer with the + * same sequence number is currently still registered as in-flight. + * + * Return: 0 on Success or -EBUSY if sequence number embedded in the xfer + * could not rbe mapped to a free slot in the xfer_alloc_table. + */ +static int scmi_xfer_inflight_register(struct scmi_xfer *xfer, + struct scmi_xfers_info *minfo) +{ + int ret = 0; + unsigned long flags; + + spin_lock_irqsave(&minfo->xfer_lock, flags); + if (!test_bit(xfer->hdr.seq, minfo->xfer_alloc_table)) + scmi_xfer_inflight_register_unlocked(xfer, minfo); + else + ret = -EBUSY; + spin_unlock_irqrestore(&minfo->xfer_lock, flags); + + return ret; +} + +/** + * scmi_xfer_raw_inflight_register - An helper to register the given xfer as in + * flight on the TX channe, if possible. + * + * @handle: Pointer to SCMI entity handle + * @xfer: The xfer to register + * + * Return: 0 on Success, error otherwise + */ +int scmi_xfer_raw_inflight_register(const struct scmi_handle *handle, + struct scmi_xfer *xfer) +{ + struct scmi_info *info = handle_to_scmi_info(handle); + + return scmi_xfer_inflight_register(xfer, &info->tx_minfo); +} + /** * scmi_xfer_pending_set - Pick a proper sequence number and mark the xfer * as pending in-flight @@ -425,6 +472,44 @@ static struct scmi_xfer *scmi_xfer_get(const struct scmi_handle *handle, return xfer; } +/** + * scmi_xfer_raw_get - Helper to get a bare free xfer from the TX channel + * + * @handle: Pointer to SCMI entity handle + * + * Note that xfer is taken from the TX channel structures. + * + * Return: A valid xfer on Success, or an error-pointer otherwise + */ +struct scmi_xfer *scmi_xfer_raw_get(const struct scmi_handle *handle) +{ + struct scmi_info *info = handle_to_scmi_info(handle); + + return scmi_xfer_get(handle, &info->tx_minfo); +} + +/** + * scmi_xfer_raw_channel_get - Helper to get a reference to the proper channel + * to use for a specific protocol_id Raw transaction. + * + * @handle: Pointer to SCMI entity handle + * @protocol_id: Identifier of the protocol + * + * Return: A reference to the channel to use, or an ERR_PTR + */ +struct scmi_chan_info * +scmi_xfer_raw_channel_get(const struct scmi_handle *handle, u8 protocol_id) +{ + struct scmi_chan_info *cinfo; + struct scmi_info *info = handle_to_scmi_info(handle); + + cinfo = idr_find(&info->tx_idr, protocol_id); + if (unlikely(!cinfo)) + return ERR_PTR(-EINVAL); + + return cinfo; +} + /** * __scmi_xfer_put() - Release a message * @@ -453,6 +538,22 @@ __scmi_xfer_put(struct scmi_xfers_info *minfo, struct scmi_xfer *xfer) spin_unlock_irqrestore(&minfo->xfer_lock, flags); } +/** + * scmi_xfer_raw_put - Release an xfer that was taken by @scmi_xfer_raw_get + * + * @handle: Pointer to SCMI entity handle + * @xfer: A reference to the xfer to put + * + * Note that as with other xfer_put() handlers the xfer is really effectively + * released only if there are no more users on the system. + */ +void scmi_xfer_raw_put(const struct scmi_handle *handle, struct scmi_xfer *xfer) +{ + struct scmi_info *info = handle_to_scmi_info(handle); + + return __scmi_xfer_put(&info->tx_minfo, xfer); +} + /** * scmi_xfer_lookup_unlocked - Helper to lookup an xfer_id * -- 2.32.0
| |