lkml.org 
[lkml]   [2022]   [Aug]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/1] serial: fsl_lpuart: RS485 RTS polariy is inverse
Date
The setting of RS485 RTS polarity is inverse in the current driver.

When the property of 'rs485-rts-active-low' is enabled in the dts node,
the RTS signal should be LOW during sending. Otherwise, if there is no
such a property, the RTS should be HIGH during sending.

Signed-off-by: Nicolas Diaz <nicolas.diaz@nxp.com>
Signed-off-by: Shenwei Wang <shenwei.wang@nxp.com>
---
drivers/tty/serial/fsl_lpuart.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index afa0f941c862f..abc3a3674bc39 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1394,9 +1394,9 @@ static int lpuart_config_rs485(struct uart_port *port, struct ktermios *termios,
* Note: UART is assumed to be active high.
*/
if (rs485->flags & SER_RS485_RTS_ON_SEND)
- modem &= ~UARTMODEM_TXRTSPOL;
- else if (rs485->flags & SER_RS485_RTS_AFTER_SEND)
modem |= UARTMODEM_TXRTSPOL;
+ else if (rs485->flags & SER_RS485_RTS_AFTER_SEND)
+ modem &= ~UARTMODEM_TXRTSPOL;
}

writeb(modem, sport->port.membase + UARTMODEM);
--
2.25.1
\
 
 \ /
  Last update: 2022-08-02 18:40    [W:0.059 / U:3.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site