lkml.org 
[lkml]   [2022]   [Aug]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v3 0/6] Add the iMX8MP PCIe support
Date
Based on the 6.0-rc1 of the pci/next branch. 
This series adds the i.MX8MP PCIe support and had been tested on i.MX8MP
EVK board when one PCIe NVME device is used.

- i.MX8MP PCIe has reversed initial PERST bit value refer to i.MX8MQ/i.MX8MM.
Add the PHY PERST explicitly for i.MX8MP PCIe PHY.
- Add the i.MX8MP PCIe PHY support in the i.MX8M PCIe PHY driver.
And share as much as possible codes with i.MX8MM PCIe PHY.
- Add the i.MX8MP PCIe support in binding document, DTS files, and PCIe
driver.

Main changes v2-->v3:
- Fix the schema checking error in the PHY dt-binding patch.
- Inspired by Lucas, the PLL configurations might not required when
external OSC is used as PCIe referrence clock. It's true. Remove all
the HSIO PLL bit manipulations, and PCIe works fine on i.MX8MP EVK board
with one NVME device is used.
- Drop the #4 patch of v2, since it had been applied by Rob.

Main changes v1-->v2:
- It's my fault forget including Vinod, re-send v2 after include Vinod
and linux-phy@lists.infradead.org.
- List the basements of this patch-set. The branch, codes changes and so on.
- Clean up some useless register and bit definitions in #3 patch.

Documentation/devicetree/bindings/phy/fsl,imx8-pcie-phy.yaml | 16 +++++++--
arch/arm64/boot/dts/freescale/imx8mp-evk.dts | 53 +++++++++++++++++++++++++++++
arch/arm64/boot/dts/freescale/imx8mp.dtsi | 46 ++++++++++++++++++++++++-
drivers/pci/controller/dwc/pci-imx6.c | 17 +++++++++-
drivers/phy/freescale/phy-fsl-imx8m-pcie.c | 150 +++++++++++++++++++++++++++++++++++++++++++++++++++++++++-------------------------
drivers/reset/reset-imx7.c | 1 +
6 files changed, 232 insertions(+), 51 deletions(-)

[PATCH v3 1/6] reset: imx7: Add the iMX8MP PCIe PHY PERST support
[PATCH v3 2/6] dt-binding: phy: Add iMX8MP PCIe PHY binding
[PATCH v3 3/6] phy: freescale: imx8m-pcie: Add iMX8MP PCIe PHY
[PATCH v3 4/6] arm64: dts: imx8mp: add the iMX8MP PCIe support
[PATCH v3 5/6] arm64: dts: imx8mp-evk: Add PCIe support
[PATCH v3 6/6] PCI: imx6: Add the iMX8MP PCIe support

\
 
 \ /
  Last update: 2022-08-18 09:20    [W:0.170 / U:1.500 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site