Messages in this thread Patch in this message | | | From | Krzysztof Kozlowski <> | Subject | [PATCH 2/4] ARM: dts: qcom: msm8226: override nodes by label | Date | Wed, 10 Aug 2022 11:05:14 +0300 |
| |
Using node paths to extend or override a device tree node is error prone. If there was a typo error, a new node will be created instead of extending the existing node. This will lead to run-time errors that could be hard to detect.
A mistyped label on the other hand, will cause a dtc compile error (during build time). This also reduces the indentation making the code easier to read.
The pre/post DTBS are the same.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org> --- arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts | 6 ++---- 1 file changed, 2 insertions(+), 4 deletions(-)
diff --git a/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts b/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts index d159188c8b95..290e1df631f0 100644 --- a/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts +++ b/arch/arm/boot/dts/qcom-msm8226-samsung-s3ve3g.dts @@ -18,8 +18,6 @@ chosen { }; }; -&soc { - serial@f991f000 { - status = "ok"; - }; +&blsp1_uart3 { + status = "ok"; }; -- 2.34.1
| |