lkml.org 
[lkml]   [2022]   [Aug]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v10 04/12] iommu: Add attach/detach_dev_pasid iommu interface
From
Hi Jason,

On 7/26/22 9:57 PM, Jason Gunthorpe wrote:
>> + /*
>> + * Block PASID attachment in all cases where the PCI fabric is
>> + * routing based on address. ACS disables it.
>> + */
>> + if (dev_is_pci(dev) &&
>> + !pci_acs_path_enabled(to_pci_dev(dev), NULL, REQ_ACS_FLAGS))
>> + return -ENODEV;
> I would probably still put this in a function just to be clear, and
> probably even a PCI layer funcion 'pci_is_pasid_supported' that
> clearly indicates that the fabric path can route a PASID packet
> without mis-routing it.

I am fine with putting above in a function to make it clear. But I am
hesitant to move this part of logic into the PCI layer.

From the perspective of IOMMU, TLPs with PASID prefix form distinct
address spaces, so it's reasonable to require ACS protection on the
upstream path.

But PCI spec doesn't require this. The interfaces defined in drivers/pci
/ats.c should work as well even the IOMMU is disabled.

> If the fabric routes PASID properly then groups are not an issue - all
> agree on this?

Yes, agreed. The iommu groups are not an issue any more. But just like
iommu_attach_device(), if multiple devices share a group, there must be
some mechanism to make sure that device drivers are aware of this fact
and only attach a shared domain to any PASID of those devices.'
Otherwise, the iommu_attach/detach_dev_pasid() might be misused.

Considering that all existing PASID use cases are singleton group case,
probably we can start our support from the simple singleton group case?

Best regards,
baolu

\
 
 \ /
  Last update: 2022-08-02 04:25    [W:0.171 / U:0.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site