Messages in this thread | | | Date | Thu, 7 Jul 2022 11:40:34 +0200 | Subject | Re: [PATCH v11 0/3] Add basic node support for MediaTek MT8186 SoC | From | Matthias Brugger <> |
| |
On 22/06/2022 17:40, Matthias Brugger wrote: > > > On 20/05/2022 14:22, Allen-KH Cheng wrote: >> MT8186 is a SoC based on 64bit ARMv8 architecture. >> It contains 6 CA55 and 2 CA76 cores. >> MT8186 share many HW IP with MT65xx series. >> >> This patchset was tested on MT8186 evaluation board to shell. >> > > Applied, thanks! >
Based on the review from Angelo I dropped patch 3 from the tree. Please address the issues and submit again.
Regards, Matthias
>> Based on next-20220519, linux-next/master >> >> changes since v9: >> - remove some merged PATCHs from series >> - reorder nodes in dts (cpu-map) >> - remove okay status in auxadc >> - remove unnecessary suffix node name for i2c >> - add pwm node >> - add dsi-phy node >> - add dpi node >> >> changes since v9: >> - add one space before equal sign of drive-strength-adv >> - corect compatible name for big cores (ca76) >> - use upper case of address in pinctrl >> - add pwrap node >> - add pwm node >> >> changes since v8: >> - change name from pins_bus to pins-sda-scl >> - correct email address >> - add capacity-dmips-mhz for each CPU >> - add ppi-partitions in gic node >> - change name to power-domain >> - remove status "okay" in scp node >> - update timer and pericfg compatible in series >> >> changes since v7: >> - add scp&auxadc node >> >> changes since v6: >> - remove unnecessary blank line >> >> changes since v5: >> - replace Mediatek a to MediaTek >> - use GPL-2.0-only OR BSD-2-Clause >> >> changes since v4: >> - correct driver clock of mt8186 >> - add power domains controller and clock controllers >> - add pinctrl, usb host, spi and i2c nodes >> - add node status in mt8186-evb.dts >> - correct some dtbs_check warnings >> >> changes since v3: >> - remove serial, mmc and phy patch from series. (already merged) >> - remove mcusysoff node >> - move oscillator nodes at the head of dts >> - change name from usb-phy to t-phy >> >> changes since v2: >> - add soc {} in mt8186.dtsi >> >> changes since v1: >> - add dt-bindings: arm: Add compatible for MediaTek MT8186 >> >> Allen-KH Cheng (3): >> dt-bindings: arm: mediatek: Add mt8186 pericfg compatible >> dt-bindings: arm: Add compatible for MediaTek MT8186 >> arm64: dts: Add MediaTek SoC MT8186 dts and evaluation board and >> Makefile >> >> .../devicetree/bindings/arm/mediatek.yaml | 4 + >> .../arm/mediatek/mediatek,pericfg.yaml | 1 + >> arch/arm64/boot/dts/mediatek/Makefile | 1 + >> arch/arm64/boot/dts/mediatek/mt8186-evb.dts | 232 ++++ >> arch/arm64/boot/dts/mediatek/mt8186.dtsi | 1016 +++++++++++++++++ >> 5 files changed, 1254 insertions(+) >> create mode 100644 arch/arm64/boot/dts/mediatek/mt8186-evb.dts >> create mode 100644 arch/arm64/boot/dts/mediatek/mt8186.dtsi >>
| |