lkml.org 
[lkml]   [2022]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] ARM: dts: kswitch-d10: use open drain mode for coma-mode pins
Date
The driver use the coma-mode pins as open-drain. Flag them in the device
tree accordingly. This avoids the following error:
[ 14.114180] gpio-2007 (coma-mode): enforced open drain please flag it properly in DT/ACPI DSDT/board file

Fixes: 46a9556d977e ("ARM: dts: kswitch-d10: enable networking")
Signed-off-by: Michael Walle <michael@walle.cc>
---
arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
index 949d49944a37..5a6c5f7c371a 100644
--- a/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
+++ b/arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi
@@ -87,22 +87,22 @@ &mdio0 {

phy4: ethernet-phy@5 {
reg = <5>;
- coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+ coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
};

phy5: ethernet-phy@6 {
reg = <6>;
- coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+ coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
};

phy6: ethernet-phy@7 {
reg = <7>;
- coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+ coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
};

phy7: ethernet-phy@8 {
reg = <8>;
- coma-mode-gpios = <&gpio 37 GPIO_ACTIVE_HIGH>;
+ coma-mode-gpios = <&gpio 37 GPIO_OPEN_DRAIN>;
};
};

--
2.30.2
\
 
 \ /
  Last update: 2022-07-04 17:11    [W:0.460 / U:1.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site