lkml.org 
[lkml]   [2022]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH v2 1/9] serial: core: only get RS485 termination GPIO if supported
On Sun, Jul 3, 2022 at 7:02 PM Lino Sanfilippo <LinoSanfilippo@gmx.de> wrote:
>
> From: Lino Sanfilippo <l.sanfilippo@kunbus.com>
>
> In uart_get_rs485_mode() only try to get a termination GPIO if RS485 bus
> termination is supported by the driver. This prevents from allocating
> and holding a GPIO descriptor for the drivers lifetimg that will never be

lifetiming

> used.

...

> port->rs485_term_gpio = devm_gpiod_get_optional(dev, "rs485-term",
> GPIOD_OUT_LOW);
> +
> + if (port->rs485_term_gpio &&

This check is incorrect. Either you need to move that after error
checking (that's what I personally prefer), or use !IS_ERR_OR_NULL().

> + !(port->rs485_supported->flags & SER_RS485_TERMINATE_BUS)) {
> + dev_warn(port->dev,
> + "%s (%d): RS485 termination gpio not supported by driver\n",
> + port->name, port->line);
> + devm_gpiod_put(dev, port->rs485_term_gpio);
> + port->rs485_term_gpio = NULL;
> + }
> +
> if (IS_ERR(port->rs485_term_gpio)) {
> ret = PTR_ERR(port->rs485_term_gpio);
> port->rs485_term_gpio = NULL;


--
With Best Regards,
Andy Shevchenko

\
 
 \ /
  Last update: 2022-07-03 20:28    [W:0.189 / U:0.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site