[lkml]   [2022]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v10 0/3] Add QCOM SNPS PHY overriding params support
Added support for overriding tuning parameters in QCOM SNPS PHY
from device tree. This parameter tuning is required to tune the
hs signal on dp/dm lines for electrical compliance to be successful.

Changes in v10:
Fixed patch headers.

changes in v9:
Fixed nitpick in driver code.

changes in v8:
Fixed nitpick in driver code.

changes in v7:
Fixed nitpick in driver code and dtsi file.

changes in v6:
Fixed errors in dt-bindings.
Fixed nitpick in driver code.

changes in v5:
Fixed nitpicks in code.
Added minimum and maximum for each parameter added in dt-bindings.
Added proper suffixes to each parameter as per dtschema.

changes in v4:
Fixed nitpicks in code.
Initial compliance test results showed overshoot in the middle of eye
diagram. The current dt values were put in place to correct it and fix
overshoot issue.

changes in v3:
Added support for phy tuning parameters to be represented in bps and
corresponding register values to be written are obtained by traversing
through data map declared in the driver.

changes in v2:
Reading the individual fields in each overriding register from
device tree.

Krishna Kurapati (2):
phy: qcom-snps: Add support for overriding phy tuning parameters
arm64: dts: qcom: sc7280: Update SNPS Phy params for SC7280 IDP device

Sandeep Maheswaram (1):
dt-bindings: phy: qcom,usb-snps-femto-v2: Add phy override params

.../bindings/phy/qcom,usb-snps-femto-v2.yaml | 88 +++++++
arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 6 +
drivers/phy/qualcomm/phy-qcom-snps-femto-v2.c | 260 ++++++++++++++++++++-
3 files changed, 352 insertions(+), 2 deletions(-)


 \ /
  Last update: 2022-07-03 15:14    [W:0.042 / U:4.332 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site