lkml.org 
[lkml]   [2022]   [Jul]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC PATCH v3 8/9] can: slcan: add support to set bit time register (btr)
Hello Marc and Max,

On Thu, Jul 28, 2022 at 12:57 PM Max Staudt <max@enpas.org> wrote:
>
> On Thu, 28 Jul 2022 12:50:49 +0200
> Marc Kleine-Budde <mkl@pengutronix.de> wrote:
>
> > On 28.07.2022 12:23:04, Dario Binacchi wrote:
> > > > > Does it make sense to use the device tree
> > > >
> > > > The driver doesn't support DT and DT only works for static serial
> > > > interfaces.
> >
> > Have you seen my remarks about Device Tree?
>
> Dario, there seems to be a misunderstanding about the Device Tree.
>
> It is used *only* for hardware that is permanently attached, present at
> boot, and forever after. Not for dyamically added stuff, and definitely
> not for ldiscs that have to be attached manually by the user.
>
>
> The only exception to this is if you have an embedded device with an
> slcan adapter permanently attached to one of its UARTs. Then you can
> use the serdev ldisc adapter to attach the ldisc automatically at boot.

It is evident that I am lacking some skills (I will try to fix it :)).
I think it is
equally clear that it is not worth going down this path.

>
> If you are actively developing for such a use case, please let us know,
> so we know what you're after and can help you better :)
>

I don't have a use case, other than to try, if possible, to make the driver
autonomous from slcand / slcan_attach for the CAN bus setup.

Returning to Marc's previous analysis:
"... Some USB CAN drivers query the bit timing const from the USB device."

Can we think of taking the gs_usb driver as inspiration for getting/setting the
bit timings?

https://elixir.bootlin.com/linux/latest/source/drivers/net/can/usb/gs_usb.c#L951
https://elixir.bootlin.com/linux/latest/source/drivers/net/can/usb/gs_usb.c#L510

and, as done with patches:

can: slcan: extend the protocol with CAN state info
can: slcan: extend the protocol with error info

further extend the protocol to get/set the bit timing from / to the adapter ?
In the case of non-standard bit rates, the driver would try, depending on the
firmware of the adapter, to calculate and set the bit timings autonomously.

Thanks and regards,
Dario

>
> Max



--

Dario Binacchi

Embedded Linux Developer

dario.binacchi@amarulasolutions.com

__________________________________


Amarula Solutions SRL

Via Le Canevare 30, 31100 Treviso, Veneto, IT

T. +39 042 243 5310
info@amarulasolutions.com

www.amarulasolutions.com

\
 
 \ /
  Last update: 2022-07-29 08:53    [W:1.532 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site