lkml.org 
[lkml]   [2022]   [Jul]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v3] srcu: Reduce blocking agressiveness of expedited grace periods further
Hi folks,

On Fri, 01 Jul 2022 04:15:45 +0100,
Neeraj Upadhyay <quic_neeraju@quicinc.com> wrote:
>
> Commit 640a7d37c3f4 ("srcu: Block less aggressively for expedited
> grace periods") highlights a problem where aggressively blocking
> SRCU expedited grace periods, as was introduced in commit
> 282d8998e997 ("srcu: Prevent expedited GPs and blocking readers
> from consuming CPU"), introduces ~2 minutes delay to the overall
> ~3.5 minutes boot time, when starting VMs with "-bios QEMU_EFI.fd"
> cmdline on qemu, which results in very high rate of memslots
> add/remove, which causes > ~6000 synchronize_srcu() calls for
> kvm->srcu SRCU instance.
>
> Below table captures the experiments done by Zhangfei Gao and Shameer
> to measure the boottime impact with various values of non-sleeping
> per phase counts, with HZ_250 and preemption enabled:
>
> +──────────────────────────+────────────────+
> | SRCU_MAX_NODELAY_PHASE | Boot time (s) |
> +──────────────────────────+────────────────+
> | 100 | 30.053 |
> | 150 | 25.151 |
> | 200 | 20.704 |
> | 250 | 15.748 |
> | 500 | 11.401 |
> | 1000 | 11.443 |
> | 10000 | 11.258 |
> | 1000000 | 11.154 |
> +──────────────────────────+────────────────+
>
> Analysis on the experiment results showed improved boot time
> with non blocking delays close to one jiffy duration. This
> was also seen when number of per-phase iterations were scaled
> to one jiffy.
>
> So, this change scales per-grace-period phase number of non-sleeping
> polls, such that, non-sleeping polls are done for one jiffy. In addition
> to this, srcu_get_delay() call in srcu_gp_end(), which is used to calculate
> the delay used for scheduling callbacks, is replaced with the check for
> expedited grace period. This is done, to schedule cbs for completed expedited
> grace periods immediately, which results in improved boot time seen in
> experiments. Testing done by Marc and Zhangfei confirms that this change recovers
> most of the performance degradation in boottime; for CONFIG_HZ_250 configuration,
> boottime improves from 3m50s to 41s on Marc's setup; and from 2m40s to ~9.7s
> on Zhangfei's setup.
>
> In addition to the changes to default per phase delays, this change
> adds 3 new kernel parameters - srcutree.srcu_max_nodelay,
> srcutree.srcu_max_nodelay_phase, srcutree.srcu_retry_check_delay.
> This allows users to configure the srcu grace period scanning delays,
> depending on their system configuration requirements.
>
> Signed-off-by: Neeraj Upadhyay <quic_neeraju@quicinc.com>
> Tested-by: Marc Zyngier <maz@kernel.org>
> Tested-by: Zhangfei Gao <zhangfei.gao@linaro.org>

Is there any chance for this fix to make it into 5.19? The regression
is significant enough on low-end systems, and I'd rather see it
addressed.

Thanks,

M.

--
Without deviation from the norm, progress is not possible.

\
 
 \ /
  Last update: 2022-07-19 10:28    [W:0.087 / U:0.804 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site