lkml.org 
[lkml]   [2022]   [Jul]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 7/8] drm/tidss: Fix clock request value for OLDI videoports
Date
The OLDI TX(es) require a serial clock which is 7 times the pixel clock
of the display panel. When the OLDI is enabled in DSS, the pixel clock
input of the corresponding videoport gets a divided-by 7 value of the
requested clock.

For the am625-dss, the requested clock needs to be 7 times the value.

Update the clock frequency by requesting 7 times the value.

Signed-off-by: Aradhya Bhatia <a-bhatia1@ti.com>
---
drivers/gpu/drm/tidss/tidss_dispc.c | 10 ++++++++++
1 file changed, 10 insertions(+)

diff --git a/drivers/gpu/drm/tidss/tidss_dispc.c b/drivers/gpu/drm/tidss/tidss_dispc.c
index c4a5f808648f..0b9689453ee8 100644
--- a/drivers/gpu/drm/tidss/tidss_dispc.c
+++ b/drivers/gpu/drm/tidss/tidss_dispc.c
@@ -1326,6 +1326,16 @@ int dispc_vp_set_clk_rate(struct dispc_device *dispc, u32 hw_videoport,
int r;
unsigned long new_rate;

+ /*
+ * For AM625 OLDI video ports, the requested pixel clock needs to take into account the
+ * serial clock required for the serialization of DPI signals into LVDS signals. The
+ * incoming pixel clock on the OLDI video port gets divided by 7 whenever OLDI enable bit
+ * gets set.
+ */
+ if (dispc->feat->vp_bus_type[hw_videoport] == DISPC_VP_OLDI &&
+ dispc->feat->subrev == DISPC_AM625)
+ rate *= 7;
+
r = clk_set_rate(dispc->vp_clk[hw_videoport], rate);
if (r) {
dev_err(dispc->dev, "vp%d: failed to set clk rate to %lu\n",
--
2.37.0
\
 
 \ /
  Last update: 2022-07-19 10:12    [W:0.230 / U:0.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site