lkml.org 
[lkml]   [2022]   [Jul]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] soundwire: qcom: Update error prints to debug prints
Date
Upadte error prints to debug prints to avoid redundant logging in kernel
boot time, as these prints are informative prints in irq handler.

Signed-off-by: Srinivasa Rao Mandadapu <quic_srivasam@quicinc.com>
---
drivers/soundwire/qcom.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
index 9df970e..a4293d0 100644
--- a/drivers/soundwire/qcom.c
+++ b/drivers/soundwire/qcom.c
@@ -573,11 +573,10 @@ static irqreturn_t qcom_swrm_irq_handler(int irq, void *dev_id)
break;
case SWRM_INTERRUPT_STATUS_NEW_SLAVE_ATTACHED:
case SWRM_INTERRUPT_STATUS_CHANGE_ENUM_SLAVE_STATUS:
- dev_err_ratelimited(swrm->dev, "%s: SWR new slave attached\n",
- __func__);
+ dev_dbg(swrm->dev, "%s: SWR new slave attached\n", __func__);
swrm->reg_read(swrm, SWRM_MCP_SLV_STATUS, &slave_status);
if (swrm->slave_status == slave_status) {
- dev_err(swrm->dev, "Slave status not changed %x\n",
+ dev_dbg(swrm->dev, "Slave status not changed %x\n",
slave_status);
} else {
qcom_swrm_get_device_status(swrm);
--
2.7.4
\
 
 \ /
  Last update: 2022-07-13 14:24    [W:0.056 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site