lkml.org 
[lkml]   [2022]   [Jul]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 25/25] iommu/vt-d: Make DMAR_UNITS_SUPPORTED default 1024
Date
If the available hardware exceeds DMAR_UNITS_SUPPORTED (previously set
to MAX_IO_APICS, or 128), it causes these messages: "DMAR: Failed to
allocate seq_id", "DMAR: Parse DMAR table failure.", and "x2apic: IRQ
remapping doesn't support X2APIC mode x2apic disabled"; and the system
fails to boot properly.

To support up to 64 sockets with 10 DMAR units each (640), make the
value of DMAR_UNITS_SUPPORTED default 1024.

Signed-off-by: Steve Wahl<steve.wahl@hpe.com>
Signed-off-by: Lu Baolu <baolu.lu@linux.intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Reviewed-by: Steve Wahl <steve.wahl@hpe.com>
Link: https://lore.kernel.org/linux-iommu/20220615183650.32075-1-steve.wahl@hpe.com/
Link: https://lore.kernel.org/r/20220702015610.2849494-7-baolu.lu@linux.intel.com
---
include/linux/dmar.h | 6 +-----
1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/include/linux/dmar.h b/include/linux/dmar.h
index cbd714a198a0..d81a51978d01 100644
--- a/include/linux/dmar.h
+++ b/include/linux/dmar.h
@@ -18,11 +18,7 @@

struct acpi_dmar_header;

-#ifdef CONFIG_X86
-# define DMAR_UNITS_SUPPORTED MAX_IO_APICS
-#else
-# define DMAR_UNITS_SUPPORTED 64
-#endif
+#define DMAR_UNITS_SUPPORTED 1024

/* DMAR Flags */
#define DMAR_INTR_REMAP 0x1
--
2.25.1
\
 
 \ /
  Last update: 2022-07-12 02:17    [W:0.105 / U:0.456 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site