lkml.org 
[lkml]   [2022]   [Jun]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [RFC PATCH 11/13] can: slcan: add ethtool support to reset adapter errors
Hi Marc,

On Tue, Jun 7, 2022 at 12:52 PM Marc Kleine-Budde <mkl@pengutronix.de> wrote:
>
> On 07.06.2022 11:47:50, Dario Binacchi wrote:
> > This patch adds a private flag to the slcan driver to switch the
> > "err-rst-on-open" setting on and off.
> >
> > "err-rst-on-open" on - Reset error states on opening command
> >
> > "err-rst-on-open" off - Don't reset error states on opening command
> > (default)
> >
> > The setting can only be changed if the interface is down:
> >
> > ip link set dev can0 down
> > ethtool --set-priv-flags can0 err-rst-on-open {off|on}
> > ip link set dev can0 up
> >
> > Signed-off-by: Dario Binacchi <dario.binacchi@amarulasolutions.com>
>
> I'm a big fan of bringing the device into a well known good state during
> ifup. What would be the reasons/use cases to not reset the device?

Because by default either slcand and slcan_attach don't reset the error states,
but you must use the `-f' option to do so. So, I followed this use case.

Thanks and regards,
Dario
>
> Marc
>
> --
> Pengutronix e.K. | Marc Kleine-Budde |
> Embedded Linux | https://www.pengutronix.de |
> Vertretung West/Dortmund | Phone: +49-231-2826-924 |
> Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |



--

Dario Binacchi

Embedded Linux Developer

dario.binacchi@amarulasolutions.com

__________________________________


Amarula Solutions SRL

Via Le Canevare 30, 31100 Treviso, Veneto, IT

T. +39 042 243 5310
info@amarulasolutions.com

www.amarulasolutions.com

\
 
 \ /
  Last update: 2022-06-08 18:34    [W:3.450 / U:0.012 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site