[lkml]   [2022]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH 1/6] Docs/admin-guide/damon/reclaim: remove a paragraph that been obsolete due to online tuning support
Commit 81a84182c343 ("Docs/admin-guide/mm/damon/reclaim: document
'commit_inputs' parameter") has documented the 'commit_inputs' parameter
which allows online parameter update, but it didn't remove a paragraph
saying the online parameter update is impossible. This commit removes
the obsolete paragraph.

Fixes: 81a84182c343 ("Docs/admin-guide/mm/damon/reclaim: document 'commit_inputs' parameter")
Signed-off-by: SeongJae Park <>
Documentation/admin-guide/mm/damon/reclaim.rst | 6 ------
1 file changed, 6 deletions(-)

diff --git a/Documentation/admin-guide/mm/damon/reclaim.rst b/Documentation/admin-guide/mm/damon/reclaim.rst
index 46306f1f34b1..6510baa91109 100644
--- a/Documentation/admin-guide/mm/damon/reclaim.rst
+++ b/Documentation/admin-guide/mm/damon/reclaim.rst
@@ -48,12 +48,6 @@ DAMON_RECLAIM utilizes module parameters. That is, you can put
``damon_reclaim.<parameter>=<value>`` on the kernel boot command line or write
proper values to ``/sys/modules/damon_reclaim/parameters/<parameter>`` files.

-Note that the parameter values except ``enabled`` are applied only when
-DAMON_RECLAIM starts. Therefore, if you want to apply new parameter values in
-runtime and DAMON_RECLAIM is already enabled, you should disable and re-enable
-it via ``enabled`` parameter file. Writing of the new values to proper
-parameter values should be done before the re-enablement.
Below are the description of each parameter.

 \ /
  Last update: 2022-06-06 20:24    [W:0.043 / U:0.556 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site