lkml.org 
[lkml]   [2022]   [Jun]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v13 1/3] phy: qcom-edp: add regulator_set_load to edp phy
On Wed 25 May 14:02 PDT 2022, Kuogee Hsieh wrote:

> This patch add regulator_set_load() before enable regulator at
> eDP phy driver.
>
> Signed-off-by: Kuogee Hsieh <quic_khsieh@quicinc.com>
> Reviewed-by: Douglas Anderson <dianders@chromium.org>

Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>

> ---
> drivers/phy/qualcomm/phy-qcom-edp.c | 12 ++++++++++++
> 1 file changed, 12 insertions(+)
>
> diff --git a/drivers/phy/qualcomm/phy-qcom-edp.c b/drivers/phy/qualcomm/phy-qcom-edp.c
> index cacd32f..7e357078 100644
> --- a/drivers/phy/qualcomm/phy-qcom-edp.c
> +++ b/drivers/phy/qualcomm/phy-qcom-edp.c
> @@ -639,6 +639,18 @@ static int qcom_edp_phy_probe(struct platform_device *pdev)
> if (ret)
> return ret;
>
> + ret = regulator_set_load(edp->supplies[0].consumer, 21800); /* 1.2 V vdda-phy */
> + if (ret) {
> + dev_err(dev, "failed to set load at %s\n", edp->supplies[0].supply);
> + return ret;
> + }
> +
> + ret = regulator_set_load(edp->supplies[1].consumer, 36000); /* 0.9 V vdda-pll */
> + if (ret) {
> + dev_err(dev, "failed to set load at %s\n", edp->supplies[1].supply);
> + return ret;
> + }
> +
> ret = qcom_edp_clks_register(edp, pdev->dev.of_node);
> if (ret)
> return ret;
> --
> The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> a Linux Foundation Collaborative Project
>

\
 
 \ /
  Last update: 2022-06-06 15:47    [W:0.190 / U:0.968 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site