lkml.org 
[lkml]   [2022]   [Jun]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 12/12] i2c: xiic: Correct the BNB interrupt enable sequence
From
W dniu 24.06.2022 o 14:05, Manikanta Guntupalli pisze:
> From: Srinivas Goud <srinivas.goud@xilinx.com>
>
> With updated AXI IIC IP core(v2.1)there is change in IP behavior
> in dynamic mode, where controller initiate read transfer on IIC
> bus only after getting the value for the number of bytes to receive.
>
> In the existing xiic_start_recv function Bus Not Busy(BNB)
> interrupt is enabled just after "slave address + start"
> write to FIFO and before the "count + stop"write to FIFO.
> Since IIC controller drives the start address of a transaction
> on the bus only after it has received the byte count information
> the above sequence can lead to spurious BNB interrupt in case
> there is any delay after "slave address + start" write to FIFO.
>
> This is fixed by ensuring that BNB interrupt is enabled only
> after "count + stop" has been written to FIFO.
>
> Signed-off-by: Srinivas Goud <srinivas.goud@xilinx.com>
> Signed-off-by: Manikanta Guntupalli <manikanta.guntupalli@xilinx.com>
> ---

[...]

Does this spurious interrupt cause any trouble or it is just ignored and
the only problem is unneeded extra CPU load?

Krzysztof

\
 
 \ /
  Last update: 2022-06-29 15:15    [W:0.275 / U:0.824 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site