lkml.org 
[lkml]   [2022]   [Jun]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 07/19] iio: adc: at91-sama5d2_adc: move the check of oversampling in its function
Date
Oversampling values are checked anyway in at91_adc_emr_config(). Remove
the checking of these from at91_adc_write_raw() and return -EINVAL
instead in at91_adc_emr_config().

Suggested-by: Jonathan Cameron <jic23@kernel.org>
Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com>
---
drivers/iio/adc/at91-sama5d2_adc.c | 18 ++++++++++--------
1 file changed, 10 insertions(+), 8 deletions(-)

diff --git a/drivers/iio/adc/at91-sama5d2_adc.c b/drivers/iio/adc/at91-sama5d2_adc.c
index 692707b6e3e3..a0661f097ccb 100644
--- a/drivers/iio/adc/at91-sama5d2_adc.c
+++ b/drivers/iio/adc/at91-sama5d2_adc.c
@@ -728,8 +728,8 @@ static void at91_adc_eoc_ena(struct at91_adc_state *st, unsigned int channel)
at91_adc_writel(st, EOC_IER, BIT(channel));
}

-static void at91_adc_config_emr(struct at91_adc_state *st,
- u32 oversampling_ratio)
+static int at91_adc_config_emr(struct at91_adc_state *st,
+ u32 oversampling_ratio)
{
/* configure the extended mode register */
unsigned int emr = at91_adc_readl(st, EMR);
@@ -755,9 +755,13 @@ static void at91_adc_config_emr(struct at91_adc_state *st,
emr |= AT91_SAMA5D2_EMR_OSR(AT91_SAMA5D2_EMR_OSR_16SAMPLES,
osr_mask);
break;
+ default:
+ return -EINVAL;
}

at91_adc_writel(st, EMR, emr);
+
+ return 0;
}

static int at91_adc_adjust_val_osr(struct at91_adc_state *st, int *val)
@@ -1650,9 +1654,6 @@ static int at91_adc_write_raw(struct iio_dev *indio_dev,

switch (mask) {
case IIO_CHAN_INFO_OVERSAMPLING_RATIO:
- if ((val != AT91_OSR_1SAMPLES) && (val != AT91_OSR_4SAMPLES) &&
- (val != AT91_OSR_16SAMPLES))
- return -EINVAL;
/* if no change, optimize out */
if (val == st->oversampling_ratio)
return 0;
@@ -1661,12 +1662,13 @@ static int at91_adc_write_raw(struct iio_dev *indio_dev,
if (ret)
return ret;
mutex_lock(&st->lock);
- st->oversampling_ratio = val;
/* update ratio */
- at91_adc_config_emr(st, val);
+ ret = at91_adc_config_emr(st, val);
+ if (!ret)
+ st->oversampling_ratio = val;
mutex_unlock(&st->lock);
iio_device_release_direct_mode(indio_dev);
- return 0;
+ return ret;
case IIO_CHAN_INFO_SAMP_FREQ:
if (val < st->soc_info.min_sample_rate ||
val > st->soc_info.max_sample_rate)
--
2.34.1
\
 
 \ /
  Last update: 2022-06-28 17:16    [W:0.163 / U:0.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site