lkml.org 
[lkml]   [2022]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/8] serial: core, 8250: set RS485 termination gpio in serial core
On Wed, Jun 22, 2022 at 05:46:53PM +0200, Lino Sanfilippo wrote:
> From: Lino Sanfilippo <l.sanfilippo@kunbus.com>
>
> In serial8250_em485_config() the termination GPIO is set with the uart_port
> spinlock held. This is an issue if setting the GPIO line can sleep (e.g.
> since the concerning GPIO expander is connected via SPI or I2C).
>
> Fix this by setting the termination line outside of the uart_port spinlock
> in the serial core.
[...]
> --- a/drivers/tty/serial/serial_core.c
> +++ b/drivers/tty/serial/serial_core.c
> @@ -1400,6 +1411,7 @@ static int uart_set_rs485_config(struct uart_port *port,
> if (ret)
> return ret;
> uart_sanitize_serial_rs485(port, &rs485);
> + uart_set_rs485_termination(port, &rs485);
>
> spin_lock_irqsave(&port->lock, flags);
> ret = port->rs485_config(port, &rs485);

That's one way to solve the issue. Another would be to push
acquisition of the port spinlock down into drivers.

I think in most drivers we don't need to take the port spinlock at all
or only for a few specific register accesses. So taking the lock here
in the midlayer is likely unwarranted. However, changing that requires
going through every single driver's ->rs485_config() callback and
checking whether it needs the lock or not. That's painful, but
unavoidable in the long run. This patch just kicks the can down the road...

Thanks,

Lukas

\
 
 \ /
  Last update: 2022-06-25 21:59    [W:0.209 / U:0.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site