lkml.org 
[lkml]   [2022]   [Jun]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 3/3] arch/*/: remove CONFIG_VIRT_TO_BUS
From
Date
Arnd,

Am 18.06.2022 um 00:57 schrieb Arnd Bergmann:
> From: Arnd Bergmann <arnd@arndb.de>
>
> All architecture-independent users of virt_to_bus() and bus_to_virt()
> have been fixed to use the dma mapping interfaces or have been
> removed now. This means the definitions on most architectures, and the
> CONFIG_VIRT_TO_BUS symbol are now obsolete and can be removed.
>
> The only exceptions to this are a few network and scsi drivers for m68k
> Amiga and VME machines and ppc32 Macintosh. These drivers work correctly
> with the old interfaces and are probably not worth changing.

The Amiga SCSI drivers are all old WD33C93 ones, and replacing
virt_to_bus by virt_to_phys in the dma_setup() function there would
cause no functional change at all.

drivers/vme/bridges/vme_ca91cx42.c hasn't been used at all on m68k (it
is a PCI-to-VME bridge chipset driver that would be needed on
architectures that natively use a PCI bus). I haven't found anything
that selects that driver, so not sure it is even still in use??

That would allow you to drop the remaining virt_to_bus define from
arch/m68k/include/asm/virtconvert.h.

I could submit a patch to convert the Amiga SCSI drivers to use
virt_to_phys if Geert and the SCSI maintainers think it's worth the churn.

32bit powerpc is a different matter though.

Cheers,

Michael

\
 
 \ /
  Last update: 2022-06-18 03:08    [W:0.146 / U:0.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site