lkml.org 
[lkml]   [2022]   [Jun]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 -next] usb: xhci: disable irq during initialization
On Thu, Jun 16, 2022 at 04:24:08PM +0800, 谢泓宇 wrote:
> Hi greg,
>
> On 2022/6/16 16:12, Greg KH wrote:
> > On Thu, Jun 16, 2022 at 04:09:33PM +0800, Hongyu Xie wrote:
> > > irq is disabled in xhci_quiesce(called by xhci_halt, with bit:2 cleared
> > > in USBCMD register), but xhci_run(called by usb_add_hcd) re-enable it.
> > > It's possible that you will receive thousands of interrupt requests
> > > after initialization for 2.0 roothub. And you will get a lot of
> > > warning like, "xHCI dying, ignoring interrupt. Shouldn't IRQs be
> > > disabled?". This amount of interrupt requests will cause the entire
> > > system to freeze.
> > > This problem was first found on a device with ASM2142 host controller
> > > on it.
> > >
> > > Signed-off-by: Hongyu Xie <xiehongyu1@kylinos.cn>
> > > Reported-by: kernel test robot <lkp@intel.com>
> >
> > the test robot did not find this original problem, it only found
> > problems with your original submission, which is different.
> >
> "Reported-by" shouldn't had been put here.
> Quote from the last email test robot sent to me,
> "If you fix the issue, kindly add following tag where applicable
> Reported-by: kernel test robot <lkp@intel.com>"
> Where should I put this? Or just ignore it?
>

Yes, you can ignore it but you properly referenced it in your changelog
area.

\
 
 \ /
  Last update: 2022-06-16 10:37    [W:0.042 / U:0.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site