[lkml]   [2022]   [Jun]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH net-next v2 0/3] dt-bindings: dp83867: add binding for io_impedance_ctrl nvmem cell
We have a board where measurements indicate that the current three
options - leaving IO_IMPEDANCE_CTRL at the reset value (which is
factory calibrated to a value corresponding to approximately 50 ohms)
or using one of the two boolean properties to set it to the min/max
value - are too coarse.

This series adds a device tree binding for an nvmem cell which can be
populated during production with a suitable value calibrated for each
board, and corresponding support in the driver. The second patch adds
a trivial phy wrapper for dev_err_probe(), used in the third.

v2: Improve commit message for patch 1; add Rob's R-b to patch 1. No
changes in the patches themselves.

Since Dan Murphy's email address bounces, cc'ing two other
addresses that have touched the driver in recent years.

Rasmus Villemoes (3):
dt-bindings: dp83867: add binding for io_impedance_ctrl nvmem cell
linux/phy.h: add phydev_err_probe() wrapper for dev_err_probe()
net: phy: dp83867: implement support for io_impedance_ctrl nvmem cell

.../devicetree/bindings/net/ti,dp83867.yaml | 18 +++++-
drivers/net/phy/dp83867.c | 55 +++++++++++++++++--
include/linux/phy.h | 3 +
3 files changed, 67 insertions(+), 9 deletions(-)


 \ /
  Last update: 2022-06-14 10:47    [W:0.219 / U:1.148 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site