Messages in this thread | | | Date | Tue, 14 Jun 2022 20:45:25 +0200 | Subject | Re: [PATCH v3] thermal: rcar_gen3_thermal: improve logging during probe | From | Daniel Lezcano <> |
| |
On 10/06/2022 22:04, Wolfram Sang wrote: > When setting up a new board, a plain "Can't register thermal zone" > didn't help me much because the thermal zones in DT were all fine. I > just had a sensor entry too much in the parent TSC node. Reword the > failure/success messages to contain the sensor number to make it easier > to understand which sensor is affected. Example output now: > > rcar_gen3_thermal e6198000.thermal: Sensor 0: Loaded 1 trip points > rcar_gen3_thermal e6198000.thermal: Sensor 1: Loaded 1 trip points > rcar_gen3_thermal e6198000.thermal: Sensor 2: Loaded 1 trip points > rcar_gen3_thermal e6198000.thermal: Sensor 3: Can't register thermal zone > > Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Applied, thanks
-- <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs
Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | <http://twitter.com/#!/linaroorg> Twitter | <http://www.linaro.org/linaro-blog/> Blog
| |