lkml.org 
[lkml]   [2022]   [Jun]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 08/17] dt-bindings: PCI: dwc: Add reg/reg-names common properties
Date
Even though there is a more-or-less limited set of the CSR spaces can be
defined for each DW PCIe controller the generic DT schema currently
doesn't specify much limitations on the reg-space names used for one or
another range. In order to prevent the vendor-specific controller schemas
further deviation from the generic interface let's fix that by introducing
the reg-names definition in the common DW PCIe DT-schema and preserving a
generic "reg" and "reg-names" properties in there. New DW PCIe device
DT-bindings are encouraged to use the generic set of the CSR spaces
defined in the generic DW PCie DT-bindings, while the already available
vendor-specific DT-bindings can refer to the common schema and define
their own reg-spaces.

Note the number of reg/reg-names items need to be changed in the DW PCIe
EP DT-schema since aside with the "dbi" CSRs space these arrays can
have "dbi2", "addr_space", "atu", etc ranges.

Signed-off-by: Serge Semin <Sergey.Semin@baikalelectronics.ru>

---

Changelog v3:
- This is a new patch unpinned from the next one:
https://lore.kernel.org/linux-pci/20220503214638.1895-2-Sergey.Semin@baikalelectronics.ru/
by the Rob' request. (@Rob)
- Split up reg-names in the same way as the interrupt-names: common,
Root Port and Endpoint specific names. (@Rob)
- Drop synonymous from the names list since the device schemas create
their own enumerations anyway.
---
.../bindings/pci/snps,dw-pcie-common.yaml | 76 +++++++++++++++++++
.../bindings/pci/snps,dw-pcie-ep.yaml | 34 +++++++--
.../devicetree/bindings/pci/snps,dw-pcie.yaml | 27 +++++--
3 files changed, 124 insertions(+), 13 deletions(-)

diff --git a/Documentation/devicetree/bindings/pci/snps,dw-pcie-common.yaml b/Documentation/devicetree/bindings/pci/snps,dw-pcie-common.yaml
index 0a524e916a9f..c6a55f90ddd5 100644
--- a/Documentation/devicetree/bindings/pci/snps,dw-pcie-common.yaml
+++ b/Documentation/devicetree/bindings/pci/snps,dw-pcie-common.yaml
@@ -17,6 +17,28 @@ description:
select: false

properties:
+ reg:
+ description:
+ DWC PCIe CSR space is normally accessed over the dedicated Data Bus
+ Interface - DBI. In accordance with the reference manual the register
+ configuration space belongs to the Configuration-Dependent Module (CDM)
+ and is split up into several sub-parts Standard PCIe configuration
+ space, Port Logic Registers (PL), Shadow Config-space Registers,
+ iATU/eDMA registers. The particular sub-space is selected by the
+ CDM/ELBI (dbi_cs) and CS2 (dbi_cs2) signals (selector bits). Such
+ configuration provides a flexible interface for the system engineers to
+ either map the particular space at a desired MMIO address or just leave
+ them in a contiguous memory space if pure Native or AXI Bridge DBI access
+ is selected. Note the PCIe CFG-space, PL and Shadow registers are
+ specific for each activated function, while the rest of the sub-spaces
+ are common for all of them (if there are more than one).
+ minItems: 2
+ maxItems: 6
+
+ reg-names:
+ minItems: 2
+ maxItems: 6
+
interrupts:
description:
There are two main sub-blocks which are normally capable of
@@ -111,6 +133,60 @@ properties:
additionalProperties: true

definitions:
+ reg-names:
+ description:
+ CSR space names common for the DWC PCIe Root Port and Endpoint
+ controllers.
+ oneOf:
+ - description:
+ Basic DWC PCIe controller configuration-space accessible over
+ the DBI interface. This memory space is either activated with
+ CDM/ELBI = 0 and CS2 = 0 or is a contiguous memory region
+ with all spaces. Note iATU/eDMA CSRs are indirectly accessible
+ via the PL viewports on the DWC PCIe controllers older than
+ v4.80a.
+ const: dbi
+ - description:
+ Shadow DWC PCIe config-space registers. This space is selected
+ by setting CDM/ELBI = 0 and CS2 = 1. This is an intermix of
+ the PCI-SIG PCIe CFG-space with the shadow registers for some
+ PCI Header space, PCI Standard and Extended Structures. It's
+ mainly relevant for the end-point controller configuration,
+ but still there are some shadow registers available for the
+ Root Port mode too.
+ const: dbi2
+ - description:
+ External Local Bus registers. It's an application-dependent
+ registers normally defined by the platform engineers. The space
+ can be selected by setting CDM/ELBI = 1 and CS2 = 0 wires or can
+ be accessed over some platform-specific means (for instance
+ as a part of a system controller).
+ enum: [ elbi, app ]
+ - description:
+ iATU/eDMA registers common for all device functions. It's an
+ unrolled memory space with the internal Address Translation
+ Unit and Enhanced DMA, which is selected by setting CDM/ELBI = 1
+ and CS2 = 1. For IP-core releases prior v4.80a, these registers
+ have been programmed via an indirect addressing scheme using a
+ set of viewport CSRs mapped into the PL space. Note iATU is
+ normally mapped to the 0x0 address of this region, while eDMA
+ is available at 0x80000 base address.
+ const: atu
+ - description:
+ Platform-specific eDMA registers. Some platforms may have eDMA
+ CSRs mapped in a non-standard base address. The registers offset
+ can be changed or the MS/LS-bits of the address can be attached
+ in an additional RTL block before the MEM-IO transactions reach
+ the DW PCIe slave interface.
+ const: dma
+ - description:
+ PHY/PCS configuration registers. Some platforms can have the
+ PCS and PHY CSRs accessible over a dedicated memory mapped
+ region, but mainly these registers are indirectly accessible
+ either by means of the embedded PHY viewport schema or by some
+ platform-specific method.
+ const: phy
+
interrupt-names:
description:
IRQ signal names common for the DWC PCIe Root Port and Endpoint
diff --git a/Documentation/devicetree/bindings/pci/snps,dw-pcie-ep.yaml b/Documentation/devicetree/bindings/pci/snps,dw-pcie-ep.yaml
index 5f12a6ac08d8..bfff723b529d 100644
--- a/Documentation/devicetree/bindings/pci/snps,dw-pcie-ep.yaml
+++ b/Documentation/devicetree/bindings/pci/snps,dw-pcie-ep.yaml
@@ -40,18 +40,25 @@ properties:
const: snps,dw-pcie-ep

reg:
- description: |
- It should contain Data Bus Interface (dbi) and config registers for all
- versions.
- For designware core version >= 4.80, it may contain ATU address space.
+ description:
+ DBI, DBI2 reg-spaces and outbound memory window are required for the
+ normal controller functioning. iATU memory IO region is also required
+ if the space is unrolled (IP-core version >= 4.80a).
minItems: 2
- maxItems: 4
+ maxItems: 5

reg-names:
minItems: 2
- maxItems: 4
+ maxItems: 5
items:
- enum: [dbi, dbi2, config, atu, addr_space, link, atu_dma, appl]
+ anyOf:
+ - $ref: /schemas/pci/snps,dw-pcie-common.yaml#/definitions/reg-names
+ - $ref: '#/definitions/reg-names'
+ allOf:
+ - contains:
+ const: dbi
+ - contains:
+ const: addr_space

interrupts:
description:
@@ -77,6 +84,19 @@ required:

additionalProperties: true

+definitions:
+ reg-names:
+ description:
+ DWC PCIe Endpoint specific CSR space names.
+ oneOf:
+ - description:
+ Outbound iATU-capable memory-region which will be used to
+ generate various application-specific traffic on the PCIe bus
+ hierarchy. It's usage scenario depends on the endpoint
+ functionality, for instance it can be used to create MSI(X)
+ messages.
+ const: addr_space
+
examples:
- |
pcie-ep@dfd00000 {
diff --git a/Documentation/devicetree/bindings/pci/snps,dw-pcie.yaml b/Documentation/devicetree/bindings/pci/snps,dw-pcie.yaml
index e0020b72288a..9e96c6d0ef48 100644
--- a/Documentation/devicetree/bindings/pci/snps,dw-pcie.yaml
+++ b/Documentation/devicetree/bindings/pci/snps,dw-pcie.yaml
@@ -40,10 +40,10 @@ properties:
const: snps,dw-pcie

reg:
- description: |
- It should contain Data Bus Interface (dbi) and config registers for all
- versions.
- For designware core version >= 4.80, it may contain ATU address space.
+ description:
+ At least DBI reg-space and peripheral devices CFG-space outbound window
+ are required for the normal controller work. iATU memory IO region is
+ also required if the space is unrolled (IP-core version >= 4.80a).
minItems: 2
maxItems: 5

@@ -51,8 +51,14 @@ properties:
minItems: 2
maxItems: 5
items:
- enum: [ dbi, dbi2, config, atu, app, elbi, mgmt, ctrl, parf, cfg, link,
- ulreg, smu, mpu, apb, phy ]
+ anyOf:
+ - $ref: /schemas/pci/snps,dw-pcie-common.yaml#/definitions/reg-names
+ - $ref: '#/definitions/reg-names'
+ allOf:
+ - contains:
+ const: dbi
+ - contains:
+ const: config

interrupts:
description:
@@ -82,6 +88,15 @@ required:
- reg-names

definitions:
+ reg-names:
+ description:
+ DWC PCIe Root Port/Complex specific CSR space names.
+ oneOf:
+ - description:
+ Outbound iATU-capable memory-region which will be used to access
+ the peripheral PCIe devices configuration space.
+ const: config
+
interrupt-names:
description:
DWC PCIe Root Port/Complex specific IRQ signal names.
--
2.35.1
\
 
 \ /
  Last update: 2022-06-10 11:07    [W:0.315 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site