lkml.org 
[lkml]   [2022]   [May]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V11 4/9] mfd: pm8008: Add reset-gpios
Quoting Satya Priya (2022-05-05 02:25:34)
> diff --git a/drivers/mfd/qcom-pm8008.c b/drivers/mfd/qcom-pm8008.c
> index c472d7f..e7c3b32 100644
> --- a/drivers/mfd/qcom-pm8008.c
> +++ b/drivers/mfd/qcom-pm8008.c
> @@ -4,6 +4,7 @@
> */
>
> #include <linux/bitops.h>
> +#include <linux/gpio/consumer.h>
> #include <linux/i2c.h>
> #include <linux/interrupt.h>
> #include <linux/irq.h>
> @@ -221,6 +222,7 @@ static int pm8008_probe(struct i2c_client *client)
> {
> int rc;
> struct pm8008_data *chip;
> + struct gpio_desc *reset_gpio;
>
> chip = devm_kzalloc(&client->dev, sizeof(*chip), GFP_KERNEL);
> if (!chip)
> @@ -239,6 +241,10 @@ static int pm8008_probe(struct i2c_client *client)
> dev_err(chip->dev, "Failed to probe irq periphs: %d\n", rc);
> }
>
> + reset_gpio = devm_gpiod_get(chip->dev, "reset", GPIOD_OUT_LOW);

Actually, this needs to come before probing irq chip right? Otherwise
irq chip could try to read/write from the pmic but it would fail.

\
 
 \ /
  Last update: 2022-05-06 16:40    [W:0.127 / U:0.840 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site